Check the battery voltage. It should read at least 13.5 volts. Also make sure the battery cable connections are tight and corrosion free. Did you check the 30 amp main fuse? It is located with the starter relay.
If the above all check okay, then look at the big plastic plug on the bottom of the ignition switch. Unplug it and make sure the connectors are not corroded or melted. Check for battery voltage at the switch, between the red wire and ground. If there's power to the switch and still nothing - then you've most likely got a bad ignition switch.
step by step instructions on how to adjust the valve on my bsa b25! There is no bsa selection under...
(More)
step by step instructions on how to adjust the valve on my bsa b25! There is no bsa selection under type so I put in a triumph!
1881 xs 400 starts fine but dies out in idle even after warm also oil leak around bottom of engine...
(More)
1881 xs 400 starts fine but dies out in idle even after warm also oil leak around bottom of engine there is a bolt for a slotted screw driver does this need to be tightened
hello i have a kmx 125 turning it in to a filed bike as the twin power values would give me that...
(More)
hello i have a kmx 125 turning it in to a filed bike as the twin power values would give me that boost and now its in an allly frame the wigths just in the eninge but the promblem is wireing i have the loom but dont know what i need and what i dont need as it was a road bike sounds a little stupid but its very fuking hard ! any hlep people ?
Have Intruder 1500LC.It seems to run strong on one cylender and weak on the other. Changed plugs. No...
(More)
Have Intruder 1500LC.It seems to run strong on one cylender and weak on the other. Changed plugs. No change. Has new battery and is weak to turn over. ????????????????????