Question about 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Need to see dye gram how to remove gear box for dyner wide glide

Posted by on

  • FLHR May 11, 2010

    Are you wanting to remove the transmission or only remove the gear set out of the transmission while still in bike?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,565 Answers

On a Big Twin, you can remove the geartrain from the transmission case without having to remove the gearcase from the engine. Basically, the "guts" come out of the case.

You'll have to disconnect the battery, remove the clutch and all other inner primary gear, remove the exhaust pipes, drain the oil from the transmission. Remove the top cover of the transmission, remove the shifter cam mechanism, remove the "trap door endplate" of the right side of the transmission along with the gear.

A service manual is recommended if you plan on doing this job yourself.

Posted on Oct 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 05 wide glide with fuil injection. it starts good ride about 2 mile and dyes out

determine if any dtcs are set and if so what ones. Check engine temperature sensor. cHECK RUNNING FUEL PRESSURE ALSO.

May 11, 2014 | 2005 Harley Davidson FXDWGI Dyna Wide...

1 Answer

How to remove the starter on a 96 dyna wide glide

Did you remove the starter gear inside the primary cover?

(the gear above the clutch)

The gear is larger in diameter that the hole in the bearing that the shaft passes through.

Jan 29, 2014 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

Looking for the bank sensor 01 dyna wide glide

Hi Anonymous, remove the left side panel then remove the electrical control mounting bracket it will be behind the bracket. Good luck.

Aug 27, 2013 | 2001 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Gear shifter keeps coming loose on the spline out of gear box

Try replacing the bolt in the shifter. If that doesn't work, you will have to replace the shifter.

Dec 11, 2012 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...

1 Answer

How do axcess fuse box wide glide fxdwg

Hi Anonymous, on a Dyna all fuses, circuit breakers, relays, and modules will be behind the left side panel cover secured by grommets, four nuts or screws. On later models the electrical panel bracket cover secured by four nuts or screws must also be removed to gain access to electrical components. Good luck and have nice day.

Jul 11, 2012 | 2001 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

I'm having trouble removing the battery from my 2004 FWDWG Dyna Wide Glide. Any suggestions?

Well. let's see if Harley has changed anything. I can tell you how the earllier Wide Glide batteries came out and we can see if Harley has changed thing drastically. I doubt it.

First, remove the seat. The bolt at the rear of the seat screws into the rear fender. Remove the bolt, raise the rear of the seat and pull it to the rear. The seat should come off. On some bikes, you may have to remove the small sissy bar by removing the two small bolts on either side of the uprights on it.

Now, you'll see the battery box on the right side of the bike. Look just rearward of it and you should see two bolt heads between the battery box and the rear wheel. The are battery tray lock bolts, loosen them but don't take them out.

Now, look just inboard of the battery into the frame. You'll see the head of a "jackbolt". Turn the screw counterclockwise and the battery tray will lower and allow you to get the top cover and the surround off. From there you can get to the cable connections at the battery post.

I hope this works for you.

Good Luck and Ride Safe.

Dec 19, 2010 | 2004 Harley Davidson FXDWG - FXDWGI Dyna...

1 Answer

I'm trying to change the battery in 2001 dyna wide glide I removed the bolt to the left of box that comes up thru a backwards c-shaped bracket and into the frame. The only other thing that I can locate is...

On the older wide glides, you had to remove the seat. There were two bolts between the battery box and the rear fender on the outside. Loosen, but don't remove these two bolts. Back under the seat just inside the frame was a "jack bolt". Turn the bolt Counterclockwise and the battery tray would lower, Clockwise to raise it back up. Once lowered, top cover and outer cover would come off the battery. I hope this helps.

Good Luck

Oct 01, 2010 | Harley Davidson FXDWG - FXDWGI Dyna Wide...

1 Answer

2010 harley dyna wide glide. when I press the

Is the clutch cable adjusted correctly, you may need to adjust the cable so that the clutch is released more fully, there will be an adjuster on either end of the clutch cable - adjust it so that the cable is tighter - but there should be a little bit of play left in the clutch - if this does not cure the problem you could have some gearbox damage,
The bike is still under warranty so take it to a harley dealers and have them look at it.

Jan 24, 2010 | 2000 Harley Davidson FXDWG Dyna Wide Glide

2 Answers

Cant find my fuse box for my 2000 harley davidson wide glide

You'll have to remove the large cover plate (pulls right off) direct opposite side of your battery cover plate to access the fuses, look to the rear of the bracket.

Sep 13, 2009 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

2002 Dyna wide glide. Will not IDLE

not running for a year! You have a varnish buildup in the low end circuit of the carb. You will need to remove the carb and do a full teardown of the carb to properly rectify this problem. SOMETIMES we are able to free up the passages by putting SEA FOAM cleaner in the tank , fill her up with fresh fuel and ride through the tank and it will clear up. SEA FOAM can be purchased at an auto parts store and is sometimes very effective. 1/4 cup to full tank fuel.

Jul 13, 2009 | 2002 Harley Davidson FXDWG Dyna Wide Glide

Not finding what you are looking for?
2000 Harley Davidson FXDWG Dyna Wide Glide Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

4341 Answers


Level 3 Expert

77202 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides