Question about 2002 Suzuki GZ 125 Marauder

1 Answer

Cleaning my baffles

What can i use to clean my baffles on my 1974 kawasaki triple i can get them out but they need help realy plugged bike has been garaged for 15 years befor i got it can u help. thanks jim

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 269 Answers

Just about any solvent will work. Just remeber it must be completely try before you install and fire it up. Seriously if any solvent remains you could have a really bad week. You can use acetone, again be really careful. Hope this helps.


Posted on Oct 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 klx 125l starts fine, idles fine. Bogs down or hesitates at half to full throttle. Checked fuel filter and air filter. Bike ran fine for years and just started this.

Sounds like the exhaust is clogged with carbon.Remove the silencer and dismantle it if you can and clean the pipe and baffles.This should help you.

Jun 18, 2011 | 2004 kawasaki KLX 125

1 Answer

Hi. My KDX 125 started cutting out like it was starving of fuel every 2mins or so*. i Took the carb' off, cleaned it, put it back on and now its not starting at all! not even any sign of ignition. The...

It may need rebuilt maby it does not have enough compression to turn over i would suggest getting a compression test done at a local bike shop. If thats the case it most likely needs rebuilt.

Nov 18, 2010 | 2000 kawasaki KDX 125

1 Answer

KLX 100 will stay running with choke fully in

have you checked the fule flow from the fule tank?
you may need to strip the carb down to give it a realy good clean out too this bike is just not getting any fule to it

Jul 06, 2010 | 2007 kawasaki KLX 250

4 Answers

My 1974 Yamaha 250 Enduro wont start I have cleaned and redone the carb. I have changed the coil pack and spark plug. Any suggestions will help Im not a mechanic by any means so not sure where to start...

you need good compression ( at least 90 psi , kicking it with the throttle open) , good crankshaft seals for sucking the fuel/air into the botton end, proper point gap and timing set for spark ( spark should be big and fat,if not the source coil is weak,, this is a flywheel magnito ignition and it needs no battery to fire the plug) if you clean the carb, make sure you also clean the choke pickup tube or it wont choke. also make sure you have the slide installed in the right direction ( not backwards and the idle is not set too high at first...compression/****-good spark at the right time-proper fuel/air ratio and it will run

Jul 04, 2010 | 1974 Yamaha DT 360

1 Answer

What to change at 70.000km?

not very much realy,,,change the plugs,,,oil filter,,,fule filter,,,air filter,,,and engine oil,,,check gear box oil level,,,check clutch cable check all brake pads,,,check tyers,,, lube all grees points and oil all other parts that need to be lubed,, check battery,,then go around bike with a good tool kit to check nothing is hanging off or about to fall off !!! if your brave give the bike a realy good clean up and a good spot of polish wont hurt it (that the bit that makes your arms hurt)
all ways rember,,, a clean bike looks so much better after a crash than a dirty bike will ????????oooow!

Mar 20, 2010 | 1999 BMW R 1100 S

2 Answers

Taking baffles out from standed exhaust

dont do it please,,the bike needs the right exhaust back presher to run right,,,you go taking out the baffles you change the back presher and the bike WILL SLOW DOWN!!!! and also run like a dog! burn out plugs,use twice as much fule unless you retune the carbs right, and sound like hell on earth, as well as going slower than it did! now think about this,,
is it realy worth it,,

Mar 20, 2010 | 1997 kawasaki VN 800 A Vulcan

1 Answer

I need the paint code for a 1974 kawasaki kz 400.looking for blue

kawask did / do not keep paint codes for there older bikes , i have emailed,phoned wrote letters about this i have had z1000 kz650s and no joy,all you can do is take the best piece you have and ask your local body shop to match it, but allow for ageing etc the new color might be a shock..
wwwkzrider com
a great web site for these bikes and lots of people looking for the same thing ..


Jan 18, 2010 | kawasaki ZX 400 Motorcycles

2 Answers

1992 kawasaki Vulcan 750 stops running

Drain gas into container. Pull off your petcock and clean all the junk out (will look like coffee grounds). Look inside your tank for rust and scale, then clean it out thorougly.A small chain dropped inside works wonders for knocking **** loose inside that you can't see or reach. Check for an inline fuel filter between tank and carbs and replace if you have one. Reassemble and put in fresh Premium gas....Good luck to you friend....Tim

May 12, 2009 | 1992 kawasaki VN 750 Vulcan

1 Answer


•A bucket for soapy water •Soap or liquid detergent; automotive cleaners will work •Gloves (to keep your hands clean) •Bug and tar remover •Degreaser and/or engine cleaner •A toothbrush •WD40 •A brush for wheel cleaning •Wheel cleaner •At least two microfiber or 100% cotton sponges •A variety of soft cotton towels and more abrasive rags •A chamois cloth for drying

Nov 20, 2008 | 1974 kawasaki Z1A

3 Answers

Kawasaki brute force 750

good chance u have a bent rod, bent valve. Need to take to shop to get checked out.

Oct 30, 2008 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
2002 Suzuki GZ 125 Marauder Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

76630 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides