Question about 1994 kawasaki ZZR 400

1 Answer

My kawasaki ninja 250r will not start. Battery is charged, it has plenty of fuel. I've only had three weeks brand new bike. Occasionally it'll run for a couple of seconds and shut off. I I turn on throttle it shuts off even faster.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 86 Answers

Check the gap on the plugs bud to eliminate that

Posted on Oct 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 kawasaki Ninja 250r Cranks but wont startt


It sounds like the float needle valves are lletting gas run into the bowl,in turn running gas into the motor,and fouling the spark plugs. Have you noticed if the oil level seems to be going UP,or the fuel level is going down? Kawasaki motorcycles are prone to leaking needle valves in the carbs for some reason. And the longer it sits,the worse its going to get.Try this,...pull the spark plugs and see if they are wet with fuel.Then,unhook the coils,and spin the motor over with the plugs out.If it shoots raw fuel about a foot out of each or ANY cylinder,then that is your problem. JUST BE SURE TO DISABLE THE COILS BEFORE SPINNING MOTOR OVER,AND DONT BE CLOSE TO THE PLUG HOLES WHEN YOU SPIN IT OVER!!
Good Luck!

Sep 26, 2012 | 2007 kawasaki Ninja 250R

1 Answer

2007 kawasaki ninja 650r. when I goto start the bike it makes a clicking sound but wont start. the clicking isnt from the starter it comes from an area by the battery.


Sounds like your hearimg the solinoid clicking, basically it makes the connection from the start button to the starter. It's often mounted right next to the battery as well. Now if your sure the battery is good and fully charged fallow the positive cable from the battery to solinoid, from solinoid to starter motor, and check each connection is tight and clean from corrosion. Also fallow the ground from the battery to the frame check for the same. If all look up to par, jump start the bike from a battery charger or vehicle with cables. If it starts, recheck the battery voltage.

Mar 23, 2012 | 2008 kawasaki Ninja 250R

1 Answer

99 kawasaki ninja EX250 motor swap for a 98 NINJA EX250 MOTOR


I would try charging the battery. Take it off and put it on a slow trickle charge overnight. Batteries usually only last 3-4 years if it is an acid battery.

Nov 27, 2011 | kawasaki Kawasaki Ex250f11 Ninja 250r...

1 Answer

Swapped a 99 kawasaki ninja EX250 motor for a 1998 kawasaki ninja EX250 motor now wont start


sounds like you have a carb problem Jason,possibly probably your float level is set too low not allowing sufficient fuel to Venturi

Nov 27, 2011 | kawasaki Ex250f8 Ninja 250r Motorcycle...

1 Answer

Ignition


These bikes have a module that will not alow the starter to engage if the battery voltage is to low. You need to hook up a battery charger and ck the battery voltage. If battery voltage is below 12.oo vdc it may not start. Ck your voltage, ck your fuel, be sure you have fresh fuel before you start it or you will run down the battery again. 

Aug 30, 2009 | 2008 kawasaki Ninja 250R

1 Answer

How does a 2002 kawasaki ninja 250r act if the clutch isnt adjust


if there is no free play when pulling the lever in, the bike will most likely take off from first gear, but when you throttle it, the clutch will most likely slip. if the lever is to loose, lots of free play, you may have a hard time getting it in gear. approx 1/4 inch free play with the lever and it will work normal... unless its ready for a new clutch. hope this helps...

Apr 25, 2009 | 2008 kawasaki Ninja 250R

3 Answers

2006 Kawasaki Ninja 250 will not start


Hi and welcome to FixYa,

Your post "engine will not turn start", are you referring to the starter motor not turning or is it cranking but will not run?
  • if no crank, check the starter relay;
  • will not run, verify that there is spark at the end of the plugs;
  • will not tun, verify that there is fuel in the bowl of the carb (drain again);
  • if it has a fuel valve, set to PRI.
Incidentally, any clicking sound when you press START? Pls postback updates.

Good luck and thank you for using FixYa.


Feb 01, 2009 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
1994 kawasaki ZZR 400 Logo

Related Topics:

778 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...