Question about 2003 Buell Blast

1 Answer

What is the proper tire pressure for my 03 Blast?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

27psi in front and rear 

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 blast 500 starts an only runs about 4 min an stalls an wont start back up it may start the next day


Hi, Mdtrikeman the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or damaged battery, 9 volts or lower.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. Gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and free downloads that you need please visit the websites below and for specific information or questions, please feel free to contact me at xlch@mail.com. Good luck and have a nice day.
Buell Blast Motorcycle Forum 2000 Buell Blast Stalls When Idling BadWeB
http://www.buellxb.com/forum/showthread.php?42173-03-Blast-stalls-when-given-gas
Buell Service Manuals PDF Download
TWIN Motorcycles Buell parts
2001 Buell Blast Owners Operators Owner Manual Factory 2001 eBay

Jan 03, 2011 | 2002 Buell Blast

1 Answer

I have bought Chevrolet Aveo hatchback 2004 and I have checked the tire pressure it was 26 for front and 20 for rear tires and I noticed it consumed lot of gas, so my concern is the proper tire pressure...


The sticker inside your drivers door frame (or in your owners manual) should give you the proper pressures. Do not use the pressures indicated on the tires. Tires fit many vehicles of differing sizes and weights ( I would say the pressures are low off hand) let me know - curious

Dec 06, 2010 | 2004 Chevrolet Aveo

2 Answers

I need to know why my tmps sensor turned on after i put new tires on my car?


Tire Pressure Monitor Sensor - TPMS read all modifications that you make in the tires, also the pressure in there. Need "reset it" to turn off this signal. Visit the dealer or autoshop, only they have the proper tool.

Hope helps (remember rated and comment this)

Aug 25, 2010 | Hyundai Sonata Cars & Trucks

2 Answers

How much air pressure in 03 Liberty?


If you do not have the owners manul then the tire manufaturers recomended pressure will be on the sidewall of the tire colest to the rim.Will be very small and give you load pounds@__ psi cold.32-44PSI but may be higher.

Jan 14, 2010 | 2003 Jeep Liberty

1 Answer

Where can I order intake boots for my 03 buell blast?


Here are some talks and purchases on the boots for your blast.

http://badweatherbikers.com/buell/messages/3842/358522.html?1212107501

Dec 26, 2009 | 2003 Buell Blast

1 Answer

How much air do I put in 2003 Accent tires


The proper tire pressure for the front and rear tires should be shown on a small sticker (placard) inside the driver door jam. Open the driver side door, and look for a sticker that shows the manufacturing date, and other information, such as the proper tire size, load capacity, tire pressure, etc.

The placard pressure is what you should ALWAYS set your tire pressure to, unless you have installed different tires/wheels than came with the car when new (and then it's anyone's guess).

The placard pressure is what the manufacturer has decided is the best pressure based on their testing for that specific vehicle. Whenever I have tire work done, I always asks the shop to inflate the tires to placard pressure. You'd be surprised, they often set the pressure wrong!

Oct 09, 2009 | 2003 Hyundai Accent

1 Answer

2003 Gr. Cherokee Tire PMS overactive with smaller sidewall tires


Hello partner. The difference in air pressure variations from a 16',17' or 20" tires is a non-factor. Any size tire will go up about 1psi per 10 degrees ambient temperature. The recommended pressure for an 03 Grand Cherokee is 33psi. So if it's a rainy 55 degrees in the great northwest when you set your pressures the temperature on your trip to Death Valley would have to climb to about 175 degrees. On a different note maybe your alarm just isn't calibrated correctly.

Apr 10, 2009 | 2003 Jeep Grand Cherokee

1 Answer

'03 Merc Mountaineer humming noise when turning


If same tires as before & air pressure set correctly, or as usual, a humming when swerving, or turning one way or the other or both, it's usually a pretty good indicator.

Mar 06, 2009 | 2003 Mercury Mountaineer

Not finding what you are looking for?
2003 Buell Blast Logo

Related Topics:

570 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buell Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

jmcpoyle

Level 1 Expert

8 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a Buell Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...