Question about 1990 Norton Norton Commander

Open Question

Amc gearbox timing quadrant - difficulty in knowing where the teeth go. Any diagram would be most appreciated. This is for a Norton AMC 1961 gearbox - fitted in a Vincent. thanks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a gift card for AMC Theatres, can they be used for Cinemax? Are Cineplex & Cinemax the same theaters?


Details of terms and conditions for AMC Theatres follows:

Gift cards are usable up to balance only to buy goods or services at any AMC Theatres®, AMC Loews®, AMC Showplace, Cineplex® Odeon, Magic Johnson and Star theatres in the U.S. Not usable to purchase gift cards. Not redeemable for cash unless required by law. Not a credit or debit card. Safeguard the card. It will not be replaced or replenished if used without authorization. If lost or stolen, replacement card with remaining value requires original proof of purchase. AMC Card Processing Services, Inc. ("AMC CPS, Inc") is the card issuer and sole obligor to card owner. AMC CPS, Inc. may delegate its issuer obligations to an assignee, without recourse. If delegated, the assignee, and not AMC CPS, Inc., will be sole obligor to card owner. Purchase, use or acceptance of card constitutes acceptance of these terms. For balance or other customer service inquiries, visit any AMC theatre, log on to amctheatres.com or call 1.800.255.0311.

Feb 12, 2015 | Audio Players & Recorders

1 Answer

Fuel line routing diagram


Back in those days there was no return line. Just had to have a vented gas cap.

Oct 04, 2013 | AMC Cars & Trucks

1 Answer

I need vacuum line diagram for 1974 amc javelin with 304 engine


That diagram was placed on a tag/sticker on the front of the radiator core support.

Jun 04, 2012 | AMC Matador Cars & Trucks

2 Answers

( I only entered Concord as my Model because there is no Hornet / Gremlin option) I need a Borg - Warner T-35 automatic for the AMC 1970 (or 1971) Hornet (or Gremlin) 232. My question is which (if any)...


Now not quite sure here and i assume your in america for this borg warner unit as they were extensively used on cars like the old rover which was then called british leyland so it would appear across the range on rover ,austin ,triumph also the old jaguars as well ,but i think you would have to change the bell housings ,These gearboxes were not difficult to repair for things like clutch linings and brake bands as any reconditioning shop for brakes and clutches should be be able to cut some ferodo material and fit for you but the rest of it ?? i wouldnt know if any parts are still available .Now as for converting it to a manual then this isnt a problem providing you get the flywheel with the gearbox and all the gearchange linkage and if possible the prop as well as it could be a different length but again any decent engineering shop could extend or shorten this for you providing you have the right end of the prop that fits into the gearbox .As for knowing exactly what is what i wouldnt know because being a europeon mechanic i have never seen this vehicle that you own.

Jan 27, 2011 | AMC Concord Cars & Trucks

1 Answer

1965 amc rambler vac diagram


There was only three vachum hoses on the 1965 the one from the carburator to distributor and the one from the intake manifold to the power brakes and maybe a PCV valve But think that was too early for PCV 1972 or 1973 is the first time it was introduced to cars.

Aug 22, 2010 | AMC Scrambler Cars & Trucks

1 Answer

I need an AMC Eagle 1981 Belt Diagram.


Hi there,
The Gates Corporation,s website;
http://www.gates.com/index.cfm
will help you identify which belts & hoses fit your vehicle, or any vehicle as long as you know what engine is in it!
Cheers, Stevie-RayG

Aug 26, 2009 | 1983 AMC American Motors Eagle

2 Answers

Cj7 rear


Jeep Axle: AMC 20
amc20_.jpg
Front Axles
Dana 44
Dana 30
Dana 27
Dana 25


Rear Axles
Chrysler 8.25"
Dana 35c
AMC 20
Dana 30
Dana 60
Dana 53
Dana 44
Timken
Dana 41
Dana 23


Jeep Axles
Upgrades
Factory Options
General


-->All AMC 20s have a 8 7/8" R&P and use a 29 spline shafts. The AMC 20 R&P is 3/8" bigger than the Dana 44, but it uses smaller shafts, smaller axle tubes, and the CJ version comes with weaker two piece shafts. The AMC20 uses a 29 spline shaft where as the later Dana 44 uses a 30 spline shaft. The AMC 20 housing tends to flex a lot which can cause breakage. This can be remedied by welding the tubes and/or adding gussets. The reason the AMC 20 flexes more than the Dana 44 is the shorter differential housing and smaller axle tubes. It's other flaw is the CJ version uses the two piece axle made up of a hub and a shaft. The hub end tends to break off under load which has created the market for one piece AMC 20 axle shafts. Unfortunately, the shafts are expensive ($350+ USD) and in some cases a special bearing must be used.
amc20co_.gif -->Identifying the gear ratio of an AMC 20 is a bit tricky. Dana axles normally have a tag on the left of the diff cover with the gear ratio at the time of build. The AMC axles have a code that has to be looked up in a table. The code is stamped on the housing boss to the left of the diff cover right near the axle tube. Good part about the stamp is it tends to stay readable longer than the tag, but you have to know the code. Since there are conflicts between what a code means for a narrow track and what it means for a wide track, don't count solely on the code to identify an axle. Bring a tape measure or know the source of the part. Specs Narrow Track AMC 20 Code Gear Ratio Diff Type AA 2.73 Open DD 2.73 Trac-Lok BB 3.31 Open CC 3.31 Trac-Lok A 3.54 Open N 3.54 Trac-Lok GG 3.73 Open Q 3.73 Trac-Lok L 4.10 Open M 4.10 Trac-Lok Wide Track AMC 20 Code Gear Ratio Diff Type D 2.73 Open DD 2.73 Trac-Lok B 3.31 Open BB 3.31 Trac-Lok A 3.54 Open AA 3.54 Trac-Lok H 3.73 Open HH 3.73 Trac-Lok C 4.10 Open CC 4.10 Trac-LokThe Trac-Lok is a limited slip differential. You may have to scrape away a lot of mud, paint, and rust to uncover the code. If you can't find the code on the rear, check the tag on the front axle. Both axles should be geared the same. The R&P ratio ranges supported by the carriers are 2.73 and 3.31-5.13. The 5.13 gear ratio is not available for the Dana 30 though, so it is rare to see it. 4.56s are the lowest common ratio between the Dana 30 and AMC 20. 5.13s are available for the Dana 44.
CJ AMC 20 The CJs used two versions of the AMC 20, the narrow track from '76-'81 and the wide track from '82-'86. Both versions use keyed, two piece shaft/hub design and 5 on 5.5" wheel bolt pattern. Supplies of AMC 20s were exhausted in 1986 and some Dana 44s were used instead in the last of the CJ-7s.
From 1976-1978 a larger 11x2" drum brakes was used on the AMC 20. After 1978, a 10x1.75" drum was used.
SJ AMC 20 The Wagoneer and full size Cherokee also used a narrow and wide track version of the AMC 20. Both SJ versions used once piece shafts and 6 on 5.5" wheel bolt pattern. Since the length and bolt pattern is different from the CJ version, the SJ shafts are not compatible without resplining and redrilling. I've never heard of anyone going to the trouble.
Model/Version Spring Pads Wheel to Wheel Years AMC 20/CJ Narrow Track 36" 50.5" '76-'81 AMC 20/CJ Wide Track 36" 54.5" '82-'86 AMC 20/SJ Narrow Track AMC 20/SJ Wide Track Last modified Friday, 03-Dec-1999 21:48:34 MST
[ Jeep Tech Main Page | Terry's Jeep Page ]

Copyright © 2001, 2000, 1999, 1998 JEEPTECH.COM
All Rights Reserved, All content with exception of private works and
corporate trademarked logos are property of Jeeptech.com

Jun 06, 2009 | 1985 Jeep CJ7

1 Answer

WIRING DIAGRAM FOR 1984 AMC EAGLE


well you have several options you can go to a dealship and have them copy the diagram for you(i do this all the time) or you can purchase a repair manual at Napa or Oreilly's for around 20 bucks. it has diagrams and schematics in it. it also has alot of instructions in it so you can do repairs yourself. By the way i'm surprised that the mechanic doesn't have these diagrams himself. I was wandering why it won't start after you changed the plugs and wires could it be that maybe the firing order is wrong. i've done that myself a time or 2. double check the the plug wires to make sure they are in the right spot. if the problem is it won't crank. chances are you have a loose ground. please rate this..thanks

Sep 05, 2008 | 1984 AMC American Motors Eagle

1 Answer

Diagram schematic



Hi There please try the following internet URL as this company holds a lot of consumer electronic manuals....Good luck...

www.hisierrahifi.com

From YUBEUT

Nov 04, 2007 | AMC Multimedia AV81HTC-DD 6-Channel...

Not finding what you are looking for?
1990 Norton Norton Commander Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Norton Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Norton Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...