Question about 2001 kawasaki ZX-6R Ninja

1 Answer

Stalls in high speed last 3 gears

Changed filters, sparks, cleaned carbs., and all air connections are good but when you shift up it actually losses speed runs like a champ in lower three

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Classic cause is pressure balance pipe from ram air inlets being disconnected or blocked at the filter in Y piece connector

Posted on Oct 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why FZR600 seems to lose two cylinders while driving, carb or spark problem?


if carbs are clean and not flooding etc then try finding out which cyls are off then swop plug caps over from good cyls and see if problem moves , if yes then fit a set of 4 new plug caps ! if no then do carbs again !!

May 20, 2014 | Yamaha FZR 600 Motorcycles

1 Answer

1987 60 hp mariner idle & high idle great, stumbles/ stalls in gear on take off, head gasket or poor idle adjustment?


Clogged idle circuits in your carbs. Clean jets and passages.
You can try suck dirt out, therefore: Screw the idle mixture screw out ( almost totally ), give full throttle ( 1 second ) and then hold your hand against the carb air intake.
This will give maximum suction and can suck the dirt trough tje circuits.
Also, first drain the carb(s) to be shure there is no water in it...

Aug 22, 2017 | Light Boating

1 Answer

My bike has been to the shop twice 4 the same problem and its still there i have no power at low revs even in first gear to the point it stalls . but at high revs the bike goes hard can u help?


apart from the obvious check air filter is clean spark plug is good and your pilot jet in carb is all clear form dirt or gummed fuel my next step would be put a tooth or two bigger rear sprocket on it to lower the gear ratio this will give more torque low speed maybe whilst you looking at the sprocket just check that some has not change the front to smaller sprocket it being few years old some one may have set to get more top end speed and sacrificed all the low end??

May 22, 2011 | 2004 kawasaki KX 250 F

1 Answer

1980 Yamaha XS 400 Special First, How do you tell if it has an electronic ignition? Second, Can't get it to start. Have put gas in spark plug holes. Didn't hit. Bike has been setting on a dirt...


First, you need a good battery. The bike does have electronic ignition. Soak the carbs in denatured alcohol for two hours after removing the float bowls, then clean with spray cleaner. Spray into every large and small hole you can find. Remove the rubber diaphragm from the center of carb prior to cleaning. New diaphragms are $196 each. Check all fuses. Put in new spark plugs, NGK-BP7ES. Clean the air filter. Get a can of spray starter fluid and spray on the air filter. The rubber mounts for the carbs are likely to be a problem once it gets running. It looks like they are still available at Babbitt's, $53 each. If un-carburetored air can get into the joints it will lean the fuel mix and cause uncontrollable high idle.

Before you sink a lot of money into the bike, check for spark. If spark is present, coast the bike down a good sized hill without any spark plugs being installed. Put the bike in 3rd gear as you go downhill then let the clutch out to turn the engine over. Now ( using the clutch lever ), shift through all the gears then neutral. If the bike will not shift properly it likely has a bent shift fork. I can't find any forks avaiable. With a bad tranny I would put it back in the dirt floor building and find a newer bike. Here is a link to Babbitt's. Please rate my answer. Thanks.
www.babbittsonline.com/pages/parts/viewbybrand/default.aspx

Aug 13, 2010 | 1980 Yamaha XS 400 Special

1 Answer

I have a 2005 trx 450. I am having engine problems here recently. What is happening is when i get up in the higher gears (2 3 4) and i hammer the throttle it stalls. I won't accelerate, it just stalls. I...


Check spark plug and air filter and fuel filter.If not, you may need carb. cleaned. Also check carb bowl vent hose for restrictions.

Jul 19, 2017 | ATVs

1 Answer

Chainsaw strarts OK but stalls


Most likely fuel "Air" problem.
Old fuel can and will gunk up the air flow jets.
Would suggest cleaning the carb and filters.
Then replace with good fuel mixture and start again. :)
Make sure the choke is set correctly and the air filters are clean.
Had a lawn mower that would NEVER crank correctly after sitting idle for the winter. Had to dis-assembly the carb and clean literally with paper clip and tooth brush. Never once had to change the spark plug or wires. After spring cleaning (LOL) it would usually crank on the 2nd pull.

Good luck!

Mar 28, 2010 | Garden

1 Answer

When i put boat in gear and acelerate the moter stalls and bassicaly runs out of petrol,its a 2002 140hp suzukii have cleaned the tank n replaced the filters and its still happening?


you need to clean the carbs. your high speed jet in each carb is most likely fully or partially clogged, this is why it will idle, but when put under a load it stalls. The engine is fuel starved. I am 99.9 percent sure a good carb cleaning will fix your problems.

Jul 21, 2009 | Boating

2 Answers

Loss of speed


Try having the carbs cleaned.

Jul 03, 2009 | Yamaha 12V Air Pump

2 Answers

1987 toyota 22r truck surges after idleing while


Just off the top of my head, guesses: Given what you've already done and the high mileage, could be carb, but I'd start with fuel filter and a good additive like Sea Foam. Also, you might want to replace the PCV and any other sensors which may be suspect.

Jul 03, 2017 | 1987 Toyota Pickup

1 Answer

Sudden Speed Up and Drop


Have your transmission fluid and filter changed. That should correct the problem.

Aug 07, 2008 | 1997 Mazda 626

Not finding what you are looking for?
2001 kawasaki ZX-6R Ninja Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...