Question about 2003 kawasaki KLX 400 SR

1 Answer

I cant remember how my throtle cabel hooks up to

I cant remember how my throtle cables hooks up to my carb

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Should be with a c nut

Posted on Oct 05, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to hook up my atari

It hooks up to the coaxial jack on the back of the tv ( antenna jack )
you will also have to get a Manual TV/Game Switch Box with Coaxial Output or a 300 to 75 OHM matching transformer or a coaxial (f-type) to female rca adapter. You can also just splice a coax cable to the Atari. There are also a converter box that will convert a coaxial input to RCA output ( Yellow,red,white) cabels

Dec 27, 2012 | Atari 2600 Console

1 Answer

How to remove the carb from a 2006 Yamaha pw80

pw 80 small kids crosser

look at this

the 50 and 80 are praticaly the same carb look at the picture nut and bolt
22 and 23 they remove the carb from the engine

u may have to remove the air box or at least the rubber joiner if there is one i expect there is so u can pull the carb out of the engine

and once removed there will be cables for throtle and choke u must remove the top of the carb to unclip the cables they can be fiddly a oil pipe inportant remember where it goes and remember to fit it back on when the carb goes on

it would not be good if u forget

best of luck if :)

Oct 30, 2012 | Yamaha Motorcycles

1 Answer

2006 Hawkeye sputters at full throtle. Take air boot and air cleaner off runs fine. put just air boot on it starts to sputter at full throtle. Not even the air cleaner just tube from carb to air clean

that might be the overflow tube and should not be hooked to anything, it's like a emergency drain for the carb and when you hooked it to the filter is pulling gas out of the carb at high motor speeds causing it to sputter .. jay

Aug 28, 2012 | Polaris ATV

1 Answer

Idles wide open

Sounds like the inner cable is too short, what you can do is gently snip off a peice
of the outer cable where it anchors, this will make the inner longer.

Oct 24, 2011 | Homelite Gas, 20 In. Bar, 46 CC, Chain...

1 Answer

How do you replace the throtle cable on a 97 sportster 1200

first you need to take apart the throttle thats is done by 2 screws under the throttle the cable will be cloped in to a slide that rotates to pull the cabel. after that fallow the bable to the engin it will clip in on a nother slide that is on the intake manifold that controls the throttle there might be a screw or two holding it, you may have to remove some things to get to it

Jun 02, 2009 | 2000 Harley Davidson XL 1200 S Sportster...

1 Answer

Starts ok wont pick up speed

check to see if the throttle cable is hooked up to the carb. look at the back of the motor and watch as you pull the the throttle to see if the cable is hooked up. if the cable looks to be working correctly then pull the spark plug up and heat it up with a blow torch and put it back in. if the motor runs good then you need a new spark plug. if those two things do not work then you need to replace the carb diapram and gaskets.

May 18, 2009 | Yard Machines Garden

1 Answer

I cant get cable

who is your cabel prvider? and make sure its on the right channel

May 17, 2009 | Disney Princess TV/DVD Combo

1 Answer

Cannot connect a VCR/DVD player to Zenith SY1959Y

you don't need a code for the vcr/dvd combo to work on your tv. You need to make sure you have hooked up the cables correctly. remember that the dvd can be hooked up with the component cabels and the vhs may need to be hooked up thru the tv cable hookup.

Jan 08, 2009 | Hitachi UltraVision CineForm 55VG825 55"...

Not finding what you are looking for?
2003 kawasaki KLX 400 SR Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides