2003 mazda 6 3.0 need the main bearing torque specs

I need main and road bearing caps torque spec.
09 Mazda cx9 3.7

Main Bearing Torque 67-74 ft lbs
Rod Bearings Torque 28 - 33 ft lbs

Tighten the bearing cap in two or three steps. Tighten it to the standard torque at the last stage. *Bearing cap standard torque Torque16 pieces at the both ends : 18.6 - 20.6 N·m(190 - 210kg·cm, 13.7 - 15.2 lb·ft)24

What is the front axle torque on a 2004 Mazda 6

I need the torque specs for the connecting rod and main be

TORQUE SPECIFICATION MAZDA 6 3.0 2003

the torque spec's are 71-89 inch pounds. start with the center bolts then work out in an opposite, (criss/cross) pattern, like you would tightening wheel lugs. please rate if this helped!

front brake rotor retaining screw 85-130 inch LBS......lug nuts 67-85 ft. LBS.....front caliper guide bolt

Fig. Loosen the remaining camshaft cap bolts using this sequence-2.3L (KJ) engine




Fig. Tighten the camshaft cap bolts using this sequence-2.3L (KJ) engine

Okay, the main bearing caps only have 10 bolts, i think your looking for the connecting rod caps, they have 16 bolts, i will list them both, theres a tightening sequnce for the main bearing caps, these are the caps that hold the crankshaft to the engine block, the connecting rod caps hold the pistons to the crank and they have 16 nuts,For a 2004 mazda 6 with the 3.0 engine the torque specs are as follows.
Connecting rod bolts step 1) 19.2 - 23.6 ft lbs.
step 2) tighten an additional 80 - 100 degrees

Main bearing caps step 1) 32.5 - 33.9 ft. lbs.
step 2) tighten an additional 175 -185 degrees.
heres a diagram for main caps to tighten in order.
hope this is helpful.