Check for spark
Ignition Coil Test
Smalleng.com
http://www.youtube.com/watch?v=L7WNBDRG4C4
You may need to use a jumper wire between the threaded part of the plug and the cooling fins. You don’t have to bend up the electrode.
If spark present put a small amount of mix in the carburetor. Does it at least try to start?
If yes you most likely have a fuel delivery problem.
If no any number of problems. Try your friendly neighborhood chainsaw shop.
Start Procedure
Cold:
- Ignition on/off to on
- Set compression release – optional step even if saw is equipped with a compression release
- Pull (close) choke, set fast idle (done when choke closed on some saws); pull starter and listen for an attempt to start. once heard (usually two pulls)
- Set compression release – optional step even if saw is equipped with a compression release
- Push (open) choke pull starter until it starts. (usually first pull)
Warm:
- Ignition on/off to on
- Set compression release – optional step even if saw is equipped with a compression release
- Pull (close) choke, set fast idle (done when choke closed on some saws) - Don’t pull with choke closed.
- Push (open) choke, pull starter until it starts. (usually first pull)
Hope this helps
Lou
×