Question about 2004 Harley Davidson FLHRS - FLHRSI Road King Custom

1 Answer

Changing battery changing batter, just disconnect and install new?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 376 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 polo and am having start up problems if left standing more than a couple of days, new batter installed a couple of months ago, any ideas???


Hello There,
If you installed a new battery it should hold the charge. Unless, your car has a higher than normal drain current (extra load permanent from the battery). An approximate way to figure out that is to watch the battery terminal when you connect the cable. If you see significant spark (between the battery post and the cable end, more than once touched to each other) or the best way to measure the current value with an amp-meter. After the meter was connected the current from a higher value should settle down less than 50 mA, called parasitic drain.
If this measured current is higher, you have something turned on (interior light or anything) or a failed component. The alternator could be at fault too. If you are able to disconnect all wires to it, and no change in the drain current value, it means the alternator is O.K.
The next thing is to pull fuses and watch the meter. At some point the current must return to the expected range.
Good luck withe the procedure!

Feb 28, 2015 | Vehicle Parts & Accessories

1 Answer

I change new AAA batter and handset not working.


check to make certain the battery's are installed the correct way, if so try to charge your battery's on a proper battery charger unit, check to make certain that the contacts in the phone are clean and polished.
if the handset was droped or got wet you may have other problems

Oct 15, 2013 | Panasonic (KX-TG1032S) Phone

1 Answer

How do I change a battery of a 2011 Cruze without affecting the radio and other electronic systems?


take the batter n a pair of jummper cabels n a tahas them to youer old batter .now keep in mind that at no time r u let the cabels come loaes of the batter .or u can put a 12 vote batter crager in the cig liter soxit n run it as the batter untill u put the new one bake in the batter old batter place i hope this holp u out

Aug 01, 2013 | 2011 Chevrolet Cruze

1 Answer

My john deere la125 seems to be drawing power wile shut down, it take a week for the batter to go dead, i've pulled the batterer and it stays charged up , I've checked the charging unit and i


What you do is power off the machine, and disconnect the negative battery cable. Put a test light or volt meter between the battery negative terminal and the disconnected negative battery cable.

You will likely have a light or voltage reading...Then you start disconnecting things....I suggest the alternator.

When you have the correct component disconnected and the test light or volt meter shows no current.

If this component is the alternator, they have diode sets inside (or somewhere else in the charging circuit) Typically one diode fails and this causes the draw that you describe. The system often still charges, but at a slightly lower capacity with the failed diode.

Doc

Nov 23, 2012 | Garden

1 Answer

Is changing the battery in this notebook as simple as merely sliding in the replacement battery?r


You are correct

1) Simply shut down your laptop

2) Disconnect it from power

3) Remove the Old Batter

4) Slid in the New Battery

5) Connect power

6) Now you should be ready to go but its always best to give any batter a bit of a charge before you use it

7)Then Switch it on and your good to go

Hope that Helped

Jaysan

Jun 16, 2012 | ASUS A52F-XE2 Notebook

2 Answers

Reset the security system after changing the batter - diesel Ram


insert key turn to on position alarm should silence
once bat conected start truck

Jan 22, 2010 | 1997 Dodge Ram 2500 Club Cab

1 Answer

My car wont start I changed my water pump n now my car wont start


It is a good idea (recommended) to disconnect the battery when working on electrical components. If you disconnected the batter, make sure the battery cables are secure on the terminals (clean terminals if necessary) - apply a terminal grease to prevent corrosion and acid build up. Also, check the connection on the alternator - it's very possible this may have been disturbed or disconnected by accident during the installation of wires. Part of your message says "my car won't start, I changed my water..." did you change your water pump? There may be a crankshaft and/or camshaft sensor near the water pump. Make sure that these are plugged in and secure. Check your ignition fuse in the fuse box, the starter relay(under the hood) and the fusable link,next to or near the battery, or starter. Check all electrical connection that may prevent the vehicle from starting.

Mar 31, 2009 | 1991 Toyota Celica

2 Answers

BATTERY


well the location of the battery is down in the right front fenderwell just in front of the right front wheel. Disconnect the negative terminal first then the positve. Take the batter holder clamp off, pull the old one out and reverse the steps in installing the new one.

Feb 25, 2009 | 1998 Dodge Intrepid

1 Answer

El radio code - bATERY DISCONNECTED


Dear Customer,

If your other system worked batter on this new battery,

1.than check your radio [power syupply connection
2.than if still problem you have to do check your radio system with another car system,
3,than you get your problem, solution definetly...

THNX

May 17, 2008 | Ford F Cars & Trucks

2 Answers

Purchased new battery, now NOTEBOOK won't work on battery after full charge


Better you first charge the battery for 16 to 17 hours and recheck the same. If problem persists, change the battery from where you bought it. that battery is faulty. And yes there is no need to install the battery from device manager. Just open the battery compartment and replace the battery with new one.

Feb 13, 2008 | Toshiba Satellite A45-S250 Notebook

Not finding what you are looking for?
2004 Harley Davidson FLHRS - FLHRSI Road King Custom Logo

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...