At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There are a few potential causes for a 2009 Volkswagen Routan's headlights not working, neither high nor low beam. One possibility is that a fuse for the headlights has blown. To check for this, locate the fuse box in your Routan, which is typically located under the dashboard or in the engine compartment. The layout of the fuses will be labeled on the cover of the fuse box. Locate the fuse for the headlights and check to see if it is blown. If the fuse is blown, replace it with one of the same amperage rating.
Another possibility is that the headlight relay has failed. The relay is an electrical switch that is used to turn the lights on and off. If the relay is bad, it will prevent power from reaching the lights. The relay is usually located in the fuse box, and again, the layout of the fuses will be labeled on the cover of the fuse box.
It can also be an issue with the headlight switch, wiring or the bulb itself. It would be best to get it checked by a mechanic.
The video above shows how to replace blown fuses in the interior fuse box of your 2000Chevrolet Tracker in addition to the fuse panel diagram location.
The fuses are usually located under the dash. Either right over the battery, right on top in the center or on the right side near the bottom by the starter solonoid. There are 2 fuses. One main fuse ( 20 amp) and one fuse for the electric clutch ( 30 amp).
However a blown fuse will not cause the motor to quit running. If the engine cranks and if you have dash lights then the main fuse is good. If the main is good and you can hear the PTO click when you pull the switch out then the PTO fuse is good also.
The charging system is a 2 phase stator. One wire is out from the stator is AC and powers the headlights. The other wire is rectified to DC and charges the battery. If the headlight wire came loose and grounded to the framwe it did no damage at all since it goes directly to ground after the headlight bulbs anyway. Just plug it back in and secure it.
Try checking both a; your fuses, and b; check your bulbs. You should have two fuse boxes, one under hood and one in or under the dash. Check those for bad, blown or weak fuses. And check your headlights bulbs for them being good and their connection. If this doesn't fix your problem, you may check out your highbeam switch.
check your fuses (all of them if you have to) for any that are blown. there is a slight chance that one quit and she didn't notice it and the other finally died. also under the hood near the battery you should be able to locate another fuse panel. take off the lid and try to locate the relay for the headlights it may have failed.
Check and confirm, that headlight bulbs are glowing.If the bulb itself is faulty, it will not light.If bulb checked out, ok, then other possibility can be headlight fuse in the engine compartment fuse box.There are two 15a fuses located in the fuse holder assembly on the driverside engine compartment.Check both this fuses.Also check the relays in the fuse compartment.-------- If any of the fuse or relay is blown, replace that and see.But if all fuses and relay checked ok, then its quite possible that problem is with head light switch itself.Its getting short.------------ This should help.Thanks.Helpmech.
×