Question about 2005 KTM EXC 450 Racing Usa

1 Answer

My 2006 ktm 450 xcw is spraying oil out of the over flow tube the one the factory routes to your carberator its everywhere only sprays when the bike is wide open and under a load bike had 110 compression and no problems holding it for 5 mins

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

Should be more tahn 110 psi in the cylinder my 85 is capable of going to 155psi and it reached 185 when the rings were new its either the ring gone or valves are leaking i would strip the pot off and inspect buddy

Posted on Oct 03, 2009

Testimonial: "ya were breackin it down friday 2 check it out thanks "

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ktm 125 sx 2003 idles but wont rev up


your pilot circut is clogged. Take out your pilot jet (this is the jet closest to the cylinder) Be sure to spray carburator cleaner thru this jet until the stream is heavy and solid. Next insert the tube from your can of carb cleaner into the hole the jet was in and spray until it comes out in two locations in the carburator. One in the throat of the carb and one directly under the front edge of the slide. Go to the back of the carburator and you'll see a couple of holes at the bottom edge of the carb that mounts to the air box. these are vent holes. Spray cleaner into them and find the hole that vents the pilot circuit and insure it is not clogged. Once all of these are cleaned your bike should run as if new. Good Luck.

Oct 08, 2012 | 2003 KTM SX 125

1 Answer

I have a ktm sxf 250 2006 model and when its hot it is very hard to kick start even with start assist spray and sometimes will not but it will roll start and also when you are at top of each gear mainly...


Using "Easy Start" or other ether based engine starting aerosols will damage the engines in the long run, reducing compression due to engine wear as the aerosol removes the oil traces off the engine bore and stripping the aluminiun from the pistons. If it were an old diesel engine, not a problem.
Check your petrol mixture settings and compression. As if the compression is low it will be hard to start.

Jan 15, 2011 | KTM 250 SX-F Motorcycles

1 Answer

How much oil does this bike require?


its all in the service manual

Jun 12, 2010 | 2006 KTM 450 SX

1 Answer

Need to no why my bike dosnt have an oil site glass


not sure bout the 4 strokes but my 250sx has got a level plug around the water pump. have a look there

May 14, 2010 | 2006 KTM 450 SX

1 Answer

Need to no why my bike dosnt have an oil site glass


Check your owners manual it will tell you how many cc or oz. to add also on alot of the dirt bikes it is stamped how much to add, buy a measuring cup and add per. bike specs.

If you don't have a manual do a internet search for your make and year of bike for how much oil to add.

There is not a dipstick or a sight glass on most dirt bikes...Hope this helps

Mar 24, 2010 | 2006 KTM 450 SX

1 Answer

2007 450 xcw cuts out when you nail the throttle (bogs), if you dial it on, it's fine. New plug, just did valve adjustment


on the carb is a mixture screw fiddle with this on pic below just turn it in and unscrew it 2 turns and try it out get back to me 4989d1b.jpg

Sep 20, 2009 | 2008 KTM 450 EXC-R

1 Answer

Oil change - how much oil do you need to put in the KTM 450 exc when filling with oil??


I use just under a quart however there is on most bikes a number near the filler plug on the case it will have the letters cc next to it this is cubic centimeters of liquid go to the metric to standard conversion chart on the web to find the metric to standard conversion to be absolutely sure of the exact amount for your bike.

Sep 12, 2009 | 2008 KTM 450 EXC-R

1 Answer

Over filled oil yzf 450


Open the air box,clean it from extra oil,renew the air filter if you have to and without the air box-air filter (or opened) try to start the bike while sraying with a carb cleaner spray through the air box towards the carbs.Don't spray too much.Little bit each time and do not twist the gas grip.Choke it too if you want.It may help.Of course before all that set the oil level to normal.

May 26, 2009 | 2004 Yamaha YZ 450 F

Not finding what you are looking for?
2005 KTM EXC 450 Racing Usa Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...