Question about 2007 Yamaha YZF-R1

2 Answers

Hard to start cutting out 2007 r1 starts up but wont tick over, cuts out occaisionallly when stopping at a junction

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi, if the 2007/2008 r1 spins fast but chgs and has to be coakst with the throttle to keep running and cuts out when the throttle is closed then it maybee due to the battery, i have fixed lots of them now afterm much fault finding by fitting a new genuine or yuasa battery. The problem is that all the power is being used to spin the engine and even once started there is not enough voltage to fire the spark and injectors properly and the charging system has not yet been able to pull the battery up. REPLACE THE BATTERY IT WILL SORT IT, PAUL (YAMAHA DEALER)

Posted on Feb 14, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 921 Answers

Run a little Seafoam maybe start out with1/4 can to two gallons gas..when you get your bike started get on the thing it will probably still have the problem until the seafoam carb/injector cleaner gets in there and does its thing...i had a very bad constant hesitation problem it took 10miles before i felt it spit it out....runs great now and i use it everymonth about 1/3 can to full tank.

Posted on Oct 03, 2009

  • steve t Apr 06, 2010

    nice fix Mr yamaha i just would have never suspected the battery because it was a 07 and i didnt think it possible for a battery to go bad that quick...i hope that the new yuasa battery i installed on my bike in oct 08 wont go bad sometime within the next five months.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I been having problems lately with starting my 08 r1.. bought it new and only has 2000 miles.. cuts on but wont turn over.. after couple tries battery drained.. but bike will start with the help of a...


you sound like you have a dead cell in your battery, if so it needs replacement. A dead cell in the battery can happen from various things, and wont hold a full charge if you put it on a tester it will give you 9-10 volts instead of 12.5 -13 volts, the coil wires run directly from the battery so it has access to full power (makes sense right?) and if your battery isn't holding under full load then that could be the fix for you

Jul 03, 2010 | 2007 Yamaha YZF-R1

1 Answer

I cant get it to start right & wont tickover


if you mean the starter is cutting out when you dip the clutch, the problem should be the starter relay.....can you be more specific of the symptoms

Feb 23, 2010 | 2001 Kia Sportage

3 Answers

Bike runs ticks over in neutral soon as iput in gear cuts out


hi...put kickstand up 1st befor putting in gear....as this how bigger hondas work its a safety thing so u carnt ride off with side stand down...but cuts engine if kickstand still down & then wont start as you in gear.....even if kickstand up wont start in gear!!...hope this helps

Jan 26, 2010 | Honda XL 125 R Motorcycles

1 Answer

When starting from cold ticks over ok .once warm if i then stop and restart it stalls at tickover


Hi, Tom and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
http://www.r1-forum.com/forums/102-00-01-r1-mechanical-help/178565-wont-idle.html
Engine starting and idle speed
Yamaha R1 YZFR1 2007 2008 Service Repair Manual Download Download Manuals...
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Dec 23, 2009 | 2008 Yamaha YZF-R1

1 Answer

Cuts out sometimes at low rpms 2000 yamaha r1


Hvae you put on an aftermarket pipe? If so I owuld recomend rejetting the carbs. It probaly happens alot when the temp changes outside.

Mar 11, 2009 | 2000 Yamaha YZF-R1

Not finding what you are looking for?
2007 Yamaha YZF-R1 Logo

815 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...