Question about 2001 Yamaha SR 125

1 Answer

91 yamaha breeze, new starter, new relay, new battery, full charge, relay clicks starter wont turn over

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Poor connection to the starter....or bad starter

Posted on Oct 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yamaha XS 1100 will not turn over just clicks


Hi, Aron before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter motor or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. Faulty ignition relay.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Troubleshooting bike that wont crank
Starter clicking repeatedly but won turn over Not the battery Any help
Yamaha XS1100SH Service Manual
OEM parts for Yamaha
Yamaha 1979 XS1100E Owner Manual

Aug 18, 2017 | Yamaha Motorcycles

1 Answer

124 CC four wheeler clicks motor, wont turn over


If the quad has an electric starter and you hear a loud click but the starter motor is not turning the engine there may be a couple of things going on. First charge the battery. Once charged try starting again, if the same symptoms take battery to a motorcycle dealer and ask them to load/drop test it. If they say it's okay, then you may have a mechanical issue such as a sized engine, hydrolically locked piston or other such problems. Most likely your issue is with the battery.

Apr 20, 2016 | Yamaha Breeze 125 Yfa1 Atv Air Intake Lid...

1 Answer

Yamaha r6 2005 wont start.


Could do with more information maria6666.

Do the ignition lights come on when you turn the key? Battery connected/Charged
Has your red kill switch on the handlebar been knocked off?
Does the starter motor turn when you press the starter button? Battery connection/charge
Does the fuel pump relay click/or fuel pump make a whirring noise when the ignition is switched on? Battery connection prob/poor earth/fault on fuel pump relay
If when the starter button is pressed the it just clicks - battery needs charging.
Has it got enough fuel in it?
Is the fuel tap turned on?

I could go on but it would be easier if you could describe what happens when you try to start it.

Basically, it needs petrol to burn and electric to make the engine turn whilst making a spark to burn the petrol.

Have you any friends that could help you? Are you in a group of bikers/friends who you could ask?

Jun 26, 2011 | 2005 Yamaha YZF-R6

1 Answer

I have A 91 EF SI....with a 93 b18b1 starter ticks but will not start....replaced starter and had it rechecked and its fine....battery has good charge.....and there is power going to starter...pgm-fi main...


It sounds like your battery needs to be replaced. When you battery has a dead cell, or is weak, the starter solenoid may click, but the starter will not turn over. Since you replaced the starter, and you have power going to the starter, I am sure you have a bad battery.

Mar 12, 2011 | Honda Civic Cars & Trucks

2 Answers

My 2006 yamaha grizzly 660 wont turnover enough to start. it started out i thought the starter was goin bad because when i hit the button to start it, it would just click. but if i kept tryin it would...


Howz your battery, is it fully charged? Charged it using a trickle charge to full capacity.
The fuses are they good or blwon? Replace if blown.
Check your sppark plug if not been replaced in the last 6-12 months

Nov 07, 2010 | Yamaha XT 660 R Motorcycles

1 Answer

Yamaha v star 1100 every time i push starter buttom i hear click in the small box with 2 30 amp fuses but starter do not engaging


first check battery for full charge 12.5 to 14 volts. second corroded battery cables can cause this symptom.third check connections to battery and starter and ground are clean and tight. fourth, click in small box maybe a malfunctioning starter relay- you can ask dealer if your bike has one. last possible starter failure.

Jun 13, 2010 | 2007 Yamaha V Star Custom

1 Answer

Replaced starter relay and stater in yamaha 1100 2001 v star


Charge battery to full, start in neutral, still clicks? Bad ground, or bad connection. Jump starter solenoid with screwdriver,etc. if motor turns over the relay is bad. Chaz Moto DC

Jan 22, 2010 | 2001 Yamaha V Star 1100 Classic

2 Answers

91 yamaha breeze,wont turn over


Check fuses. Check voltage. Could be a burned, or just broken fuse. Could be a dead battery. Could be as simple as poor battery connections. If not, perhaps the following will help:

A starter can be tested in a very simple way, by applying 12vdc to the power input, and grounding the case. If it spins, then it's on to step 2, checking connections.

Starters are much too simple to be more complicated than that, but the electrical system can be. Check the circuit between the relay and the starter. Is is a direct wire with no breaks? If so, check the voltage at the power output and input of the relay. If it is good, check the power input and grounding of the starter.

Most new bikes have a clutch switch, and it may interrupt the 12vdc to the starter, without affecting the relay. Same thing goes for the nuetral switch.

Try starting in nuetral, with the clutch pulled. Check the relay for conections that you may have taken off, and not replaced. Same thing for the starter.

Oct 01, 2009 | 2000 Yamaha DT 125 R

1 Answer

2003 yzf r1 turns over slowly/starter relay makes clicking noise


Hi, Tom it should be noted that in order to "PROPERLY" diagnosis any electric starter issue it is "IMPERATIVE" that you begin with a fully charged battery 12.5 volts or better and be able to pass a proper load test, and the usual suspects are:
1. Battery terminals have loose or corroded connections.
2. Battery cables faulty due corroded or broken internal wiring at the cable connector especially the "NEGATIVE" cable which needs to be checked at "BOTH" ends.
3. Battery voltage, 12.5 volts or better,to the main circuit breaker to the ignition switch to the security/ignition fuse to the TSM/TSSM module to the engine stop/run switch to the starter button to the starter relay to the green wire that connects to the starter solenoid has dropped more than 1/2 volt.
4. With a voltmeter connected to the battery, the ignition switch in the on position, the kill switch in the run position, the starter button depressed, starter engagement should not bring voltage below 8-9 volts.
If a lower voltage is produced a proper battery load test should be performed with a load tester to validate battery integrity or battery replacement.
5. Faulty starter relay, check continuity.
6. Faulty starter solenoid, check contact plate and shoes for excessive electrical erosion/etching, refurbish as necessary or invert contact plate and use the virgin backside. Check contact shoes for being loose. Replace solenoid if the negative function is still a final outcome.
7. Faulty starter, bench test starter with a 12-volt battery if negative function check, decontaminate and undercut armature commutator segments as necessary, check segments with an ohmmeter probe each one and the segment next to it for shorts. Have the armature tested with a growler and field coils, and brush plate with an ohm-meter for opens, shorts or grounds. Replace brushes if less than .438" It is generally cheaper to overhaul/refurbish a starter motor than buy a new one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Bike has trouble starting Won turn over clicks sometimes Bad battery...
http://www.r1-forum.com/forums/102-00-01-r1-mechanical-help/39482-bike-wont-start-clicking-sound-under-seat.html
https://r1videos.files.wordpress.com/2011/04/2002-2003-yamaha-r1-service-manual.pdf
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Apr 20, 2009 | 2003 Yamaha YZF-R1

1 Answer

I have a yamaha xvs 650 dragstar converted to a trike it has been stood for 3 months. when i try to start it there is a fast clicking but the the engine does not turn over but will start easy with a bump...


bike needs a new battery. battery is no longer capable of holding a full charge no matter what a trickle charger says. batteries wear out over time. expect 2-3 years from a motorcycle battery.

the clicking sound you hear is the relay flipping between open and close as it tries to get the right amount of amperage to turn the starter.

Mar 04, 2009 | 2001 Yamaha V Star 1100 Classic

Not finding what you are looking for?
2001 Yamaha SR 125 Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...