Question about 2002 Suzuki GSX-R 600

1 Answer

While i was riding,the digital guage for my speed and the rpm guage quit working. it also stopped my turn signals from working.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check Signals fuse...

Posted on Oct 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 yahamah vmax 700 turn signals, brake light tempt gauge and tact stop working


remove headlight and check all connections and wires coming out of it and pass round the frame etc ! P....

Nov 25, 2013 | Motorcycles

1 Answer

2000 FXD super glide..47k miles..riding at highway speed my battery got super hot,tach stopped,speedometer stopped and then engine stopped running.i can not touch battery box without burning my self.s


Check the regulator. It sounds as if it has packed in, when the engine is at idle the alternator output is low, but when revved it will be higher, the regulator controls the top end of the voltage range. Also check the battery connections are tight and free from corrosion.

Mar 23, 2012 | 2002 Harley Davidson FXD Dyna Super Glide

1 Answer

After cleaning and polishing my '01 Fat Boy & checking that everything was working b4 ride. My SPEEDO stopped working, (black out #1) on the ride. Pulled over to check it out. At the same time, I...


The problem is most likely related to the speed sensor down on the tranny. Most likely it got wet and either shorted out or needs cleaned, but most likely it needs replaced, Do you have a Factory Manual as well as the Electronic diagnostics manual. You can put the bike into diagnostic mode and it will tell you what the problem is. If it is the speed sensor that crapped out . That would cause the speedo to illuminate, but not read anything. Also, it would cause the Speed/RPM cancel function to fail. Does the speedo illuminate? If not, you either have a dead speedo, or a short to its power. The only other thing is the ignithion switch, if water got into this and caused a short that would also cause this issue, try wiggling it around and see if it makes better contact and see if that helps, might just have to let it sit in the sun for a while and dry out and left over moisture. I assume you checked all the fuses?

A couple of questions though. Do the turn signals cancel when you bank turn the bike? There are two ways that the bike cancels the signals. Either via Speed/RPM ratio, or via the bank angle sensor inside the TSSM (Turn Signal / Security Module).

Jul 03, 2011 | 2001 Harley Davidson FLSTF - FLSTFI Fat...

1 Answer

2000 mpv . my dash and turn signals stopped working. i have no fuel guage, odometer, rpm, temp guage or turn signal. the turn signals do work if the hazard lights are turned on. the battery also goes dead...


drivers side kick pannel remove it and you will see lots of conectors make sure that they are pluged in i have see this problem befor. or boky controll mod is shot

Nov 28, 2010 | 2000 Mazda MPV

1 Answer

Tansmission dont shift rpm and sedometer dont work


it sound like the speed sensor quit and the trans needs that signal so start with the speed sensor.

Oct 07, 2010 | 2001 GMC Sierra Crew Cab

2 Answers

HAve a 2003 Chry. Town & Country, 124K. The


Try output sensor for the transmission (it is similar to a vehicle speed sensor), these can control the speedo and shifting. Not sure if it does anything to the rpm guage, but very possible.

Nov 14, 2009 | 2003 Chrysler Town & Country

1 Answer

Turn signal, tachometer, fuel and temp guage stopped working


you should pull out the gauge cluster and check the connector on the back side of the cluster.. i bet that is the issue

Jul 18, 2009 | 1989 Honda Accord 4 Door

Not finding what you are looking for?
2002 Suzuki GSX-R 600 Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...