Question about 2005 Harley Davidson FLSTSC - FLSTSCI Softail Springer Classic

1 Answer

MY HARLEY 2005 SOFTAIL WONT START I HAVE LIGHTS ,HORN THE ALARM IS OF BUT WHEN I PRESS THE STARTER NOTHING

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 355 Answers

Well i would make sure you have at least 12 volts at battery then make sure all ground at battery are tight and pos on battery is tight the at starter make sure the big wire has 12 volts or more at it then the little wire going to starter solenoid when you push but should get 12 volts at it if not you may have bad ignition or security system may be looking it out but the little key light may be flashing if it is hope this helps

Posted on Sep 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heritage softail will not start unless I jump around the starter relay in the fusebox new relay in and still nothing I dont know if the security system is preventing the bike from turning over


Hi, Tim and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand or clutch pull in switch/sensor.
10. Security alarm needs a reset.
11. Starter control circuit, relay, or solenoid faulty.
12. Main fuse or circuit breaker may be blown or faulty.
13. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below and for more specific information or questions at no charge please feel free to contact me at xlch@mail.com. Good luck and have nice a day.
Harley Davidson Softail Won Start
Harley Davidson service manual Mark workshop
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://www.harley-davidson.com/content/h-d/en_US/home/owners/maintain-your-bike/owners-manual.html
Instant Tech Relief A must have !!! Absolutely "FREE"

Feb 08, 2017 | 2005 Harley Davidson FLSTC - FLSTCI...

1 Answer

Why won't it crank?


Hi, Robert and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Faulty starter button.
8. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below, and for specific information or questions please feel free to contact me at xlch@mail.com. Good luck and have nice a day.
Harley Davidson Softail Won Start
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...
harley davidson wont start after fall
Harley Davidson Manuals Mark Workshop


Dec 12, 2015 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Won't start


Hi Anonymous, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections check negative cable at "BOTH" ends. (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to on.
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.
7. Security alarm not disarming
For a prime suspect please visit website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...
Harley Diagnostic Codes 04 to Present

Jan 11, 2013 | 2011 Harley Davidson FLHTK Electra Glide...

1 Answer

Red key light on dash 2005 softail harley on and indicators not working headlight on but bike does not start


Hi Anonymous, you may need an alarm reset, for more information about your question please visit the websites below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Nov 10, 2012 | Harley Davidson Motorcycles

1 Answer

How to reset alarm on heritage softail, bike wont


Set the alarm by holding the key fob button until you see running lights flash twice. Turn off the alarm by pushing the key fob button twice and the lights will flash once.

Aug 29, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Car alarm stopped working.. Car wont start


the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.

Feb 20, 2009 | 1994 Volkswagen Jetta

Not finding what you are looking for?
2005 Harley Davidson FLSTSC - FLSTSCI Softail Springer Classic Logo

517 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...