Question about 1981 Suzuki GS 750 L

1 Answer

1986 suzuki gs450, starter selanoid clicks, starter wont run, can the selanoid be the problem? or the cdi?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 232 Answers

If the bike start by pushing it , i believe that your battery would be at fault and not your selonoid .
the solonoid can be tested by arching the terminals with a spare battery but make sure the main battery is unplugged .
Also , try to push your bike in gear for a few metres and try to start it after as your starter motor could be sticking .
try this first before going to buy anything and let me know how you go .
Be very careful to disconnect your battery first

Posted on Sep 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi have a 1986 cavalcade 1400 LX was running fine last week now it won't start at all any ideas


Hi, Jim if it turns over then the usual suspects are:
1. Fuel tank empty.
2. Fuel supply valve/petcock turned off.
3. Fouled spark plugs.
4. Engine flooded as a result of overuse of the enricher.
5. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
6. Fuel valve/petcock or filter clogged.
7. Fuel line to carburetor or throttle body pinched or kinked.
8. Carburetor float stuck.
9. Fuel injectors clogged.
10. Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
12. Loose or corroded wire connection at the coil, battery or plug between ignition sensor and CDI box.
Spark plug cables in bad condition and shorting check for leakage in the dark, cable connections loose, or connected to the wrong cylinders.
13. Ignition timing incorrect due to a faulty MAP, CKP, O2, TPS, sensors.
14. Faulty neutral, clutch lever, or kickstand safety switch.
15. Faulty fuel pump or fuse or relay.
16. Faulty CDI box.
17. A stuck bent or burnt valve.
18. Tip over sensor needs a reset.
19. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.suzukicavalcade.com/Maintenance/clutchswtch.htm
http://meiguohosting.com/How-to-fix-start-problem-for-your-1986-Suzuki-GV1400-Cavalcade-LXE
1986 1987 1988 1989 1990 Suzuki GV1400 Cavalcade models Service Repair...
OEM parts for Suzuki
Suzuki GV1200GLG Owner Manual

Dec 29, 2016 | 1986 Suzuki GV 1400 Cavalcade LX

2 Answers

86 suzuki savage 650 new battery new starter new solenoid but wont start


Hi, Vera and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty ignition switch.
6. Faulty starter button.
7. Faulty kickstand or clutch pull in switch/sensor.
8. Security alarm needs a reset.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Thread Suzuki Savage won start Help Newbie
SUZUKI LS650P Manual
OEM parts for Suzuki
Suzuki LS650 Savage 1986 2004 Workshop Repair Service Manual Download...

Jul 17, 2016 | Suzuki Motorcycles

1 Answer

I have gs250 . Changed battery and now no ignition at all. Is it the transponder?


Hi, Craig and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty ignition switch.
6. Faulty starter button.
7. Faulty kickstand or clutch pull in switch/sensor.
8. Security alarm needs a reset.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Suzuki GZ250 won turn over motorcycles
Will Not Turn Over The FZR Forum
Suzuki GZ 250 Will Not Start
http://suzukservicemanuals.com/suzuki-gs250-gs450-gs500-gs550-gs750-gs1000-service-repair-manuals

Jul 03, 2016 | Motorcycles

1 Answer

Where is the Starter located on a 1985 Suzuki gs450


Directly under the carburators. There is a hump like metal cover with a bolt at each end facing straight up that covers the starter. the starter itself has 2 bolts in it that hold it to the crankcase.

Feb 23, 2015 | Suzuki Motorcycles

1 Answer

Bike wont start. starter will turn over but no spark to plugs.can anyone help?


Check all wiring connections on cdi unit - just follow spark plugs leads back. If all cables are ok then you need to check the cdi unit out. Check that cut out switch is not on, although it should not tunr over, if this was the case

Sep 24, 2013 | 1986 Honda VT 1100 C

1 Answer

1997 yamaha xj600 wont spark


Spark plugs. Or the coils. Just because there is power going to them doesn't mean they are working. But as they are fired by the CDI unit you might like to look there. Mine was a failed coil. If the problem is on both coils, it can only be the CDI.

Jun 21, 2013 | Yamaha XJ 600 Motorcycles

1 Answer

1980 Suzuki GS450, jump started my bike and now no spark, I blew the main fuzz, replaced it but still now spark, could the Igniter have gone bad or other ignition related problem be why it has no spark, I...


It is OK to jump start your motorcycle from a car battery as long as you do not crank the starter too long (it will burn the armature) and as long as the car/other vehicle is not running when you jump start your bike ( you can damage your electrical components( igniter box)). See if you can exchange one with a friend to see if that is the bad component.

Nov 08, 2010 | 1980 Suzuki Gs 550 L

1 Answer

1986 Suzuki GS 450, free manual online


how o hook up electrical harness....what goes to what ....been stuck for months now haha

email back at wilernessalex@aol.com subject title gs450

Jun 14, 2010 | 1984 Suzuki Gs 550 L

1 Answer

1982 Suzuki GS850 GL will only run with the starter button held


Obviously the CDI is picking up power from the starter button. Check the ignition key switch for proper operation. Chances are that whatever fried the loom also fried part of the switch. Alternate to that, trace the wire powering the CDI system, disconnect it at the source (starter button connection), then find a power source that is live only when the key is turned on and then hook the CDI wire up there.

an I get a “very helpful” rating on this answer?

Aug 18, 2009 | 1982 Suzuki GS 650 GT

Not finding what you are looking for?
1981 Suzuki GS 750 L Logo

Related Topics:

560 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...