Question about Honda XLR 125 R Motorcycles

2 Answers

Necht 125 gy.cant start.(no product selection so put in honda)

Hi,novice biker here!!..i brought a necht 125 gy,can not get it 2 start on button or kick start.i think the prob is something 2 do with battery,on the negative side of battery i have a green wire with spaded conection.(looks right)but on positive side of battery i have a thin and a thick red wires that are just striped and wrapped round conection,and has no spaded conection(dosent look right).i have all lights working,brake indicators,neutral light, but no power to start it up?any ideas would be extremley hopeful.thanks...toby

Posted by on

  • tobymfrance Sep 28, 2009

    thanks...a....like i said im a novice so most of what u said makes little or no sense to me....bike was working fine until the positive red wires snapped of spaded connection,i therefore stripped back the wires and wrapped them round possitve connection on battery thinking that this would work as normal,but hey just my luck it didn't.i am in the process of stripping bike down now 2 get 2 fuse box,do u think that cud be the prob?????

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Can you tell me where to get parts for this bike please

Posted on Jun 23, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 8,404 Answers

Hi Novice.

Sounds like you have a project. The engine will turn over? And you do have compression?

I agree with your accessment on the carb - probably needs work and maybe even a professional rebuild.

The electric sounds like it needs lots of cleaning up.

Do you have spark at the plugs? Are you able to check time? Points clean? Check all this stuff. You can find the answers to most of your questions at the Honda Riders Club page and elsewhere (like what is the gap for the points - what plug and gap - where are the time marks) It is too much to put here.

The starter switch operates a starter relay. It may not function at all. Find it and check your voltages. should be 12 volts on three of the 4 lugs, 2 lite wires and two heavy wires.

It is possible that all that works but the starter doesn't. You can jump the starter from the battery with a heavy cable to see it it actually operates. MAKE SURE THE BIKE IS IN NEUTRAL BEFORE YOU TO THIS.

I think this will gte you started.

Good luck with your project.

a

Posted on Sep 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put my Honda nsr 125 on a warm up after a warm up revved up then it cut &won't start back up , iknow the power valve servo has gone paid for one , has had new spark plug and air filter does spark


Hi Anonymous, and the usual suspects are:
1. Enrichner system plugged, not properly functioning or improperly operated.
2. Fuel overflow.
3. Restricted fuel supply.
4. Gas cap and or fuel tank not venting properly.
5. Plugged slow jet or passages.
6. Inlet system air leak.
For more information about your issue please visit the websites below. Good luck and have a nice day.
Honda NSR 125 won't start after cold Xmas
My Nsr 125 Wont Start Please Help
1988 1994 Honda NSR125 Service Manual Moto Data Project
http://www.vol-training.com/guides/honda-nsr-125-parts-manual.pdf
Honda nsr 125 Owners manual

Jan 02, 2016 | Honda Motorcycles

1 Answer

How can I harden up the front forks on my Honda 125 Varadero please


Measure the diameter of the springs top,cut pipe(Usually stainless steel)and remove the tops of the forks,install the spacers in each fork tube and enjoy-Experiement with the lengths,typically start with 1 1/2~3 inches.....You can also change the thickness of the fork oil...The tubed method does not require higher air pressure to work....

Sep 15, 2014 | 2004 Honda XL 125 V Varadero

1 Answer

Gy 125 starter motor jammed


Hi, Anonymous in order to diagnose the starter circuit you must start with a fully charged battery, 12.5 volts or better and be able to pass a proper load test if necessary. The battery cables and terminals must be clean and tight. The "NEGATIVE" cable is famous for corroding and or breaking inside the harness, check the connectors at both ends. Check your starter relay with a test light for continuity, it could be faulty due to corrosion and sticking in a closed configuration, another claim to fame. Finally, there is the starter solenoid, low battery voltage or faulty battery connections will cause extremely high amperage at the plate and contact shoes and rob the hold in coils of much-needed voltage. In extreme cases, the solenoid plunger plate will literally weld itself to the contact shoes, keeping the circuit closed and thus permanent engagement. Another scenario is unacceptable voltage drop to the starter solenoid from the ignition switch to the starter relay to the starter button, and finally to the solenoid. Remove the green wire from the starter solenoid and hook up the positive lead of your volt meter to the green wire connector and ground the negative lead. Turn on the ignition switch and depress starter button, the voltage reading should be no more than .5 volt less than the battery voltage. If it is more than .5 volt you need to backtrack that part of the circuit with your volt meter until you find the voltage robbing offender. Next remove the 3 screws that secure the solenoid cover and remove the plunger, dress the plate and the contact shoes of arching residue and make sure the contact shoes are tight and secure. If you have done all of the above, replace the green starter button wire, hook up your voltmeter to the battery and check the voltage drop when you start the engine, anything below 9 volts could indicate a faulty battery and a proper load test should be performed. For more information about your issue and free downloads that you will need please visit the website below. Good luck and have a nice day. How to diagnose and recognise starter motor problems
Servicing rebuild your starter motor
Starter solenoid relay
Motorcycle Manuals
Chang Jiang GY 125 2007 service manual DOWNLOAD FREE FULLMANUALS COM


Jan 14, 2014 | 2007 ChangJiang Gy 125

1 Answer

2004 Honda CBR 125 R carburetor keeps flooding


Hi, Ginamar429 and the usual suspects are:
1. Dirt or other foreign matter between float valve and its seat.
2. Float valve sticking.
3. Float valve and/or valve seat is worn or damaged.
4. Float misadjusted.
5. Float cracked, leaky or damaged.
6. Excessive "PUMPING" of hand throttle grip.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://www.bobistheoilguy.com/forums/ubbthreads.php?ubb=showflat&Number=2335721
Carburetor Carb Leaking Gas How to Fix Repair it Motorcycle Honda DIY...
Honda CBR125R Owner Manual service
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR125RW Owner Manual

Oct 06, 2010 | 2004 Honda CBR 125 R

1 Answer

I have a leike lk 125 gy-2 bike and am having problems


Leike Lk 125 Gy-2 i cant find an insurance company please help me they havent even got the model on go compare

Jul 05, 2010 | 2005 MBK Skyliner 125

1 Answer

Wantin to upgrade my motorbike


Yes they are the same frame and will interchange. I would get everything with the new motor. Exhaust-carbs-air box. You may need to get the CDI box but i'm not shure on that.

Nov 20, 2009 | 1998 Honda CA 125 Rebel

1 Answer

Battery


hi there i have been on the internet and the battery goes onder the seat

Sep 10, 2009 | 1983 Honda XL 125 R

1 Answer

Confirm entry point for "gear" oil gc 125 honda


the gear oil is the engine oil kept in the sump at th bottom of the engine

Feb 28, 2009 | 2001 Honda CB 125 T

1 Answer

Daihatsu Leike scooter just not cranking


late reply but in case other users need help with this, i had the same problem with my LEIKE LK 125 GY-2... Normally there sucking pipe to the carb comes loose or falls off... Just reconnect it :) Jamie

Feb 01, 2009 | 2005 MBK Skyliner 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...