Question about 2005 Kymco Xciting 250

1 Answer

Hullo I have 2006 Kymco Bug Hawk and I want to access the liquid coolant container. What cowlings if any do I remove to do so. Thankyou

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 302 Answers

A service manual is a valuable tool with an aging bike. I suggest the dealer/mfr. or Clymer books. In the meantime, go to the library reference section...646 stacks should have what you need.

Posted on Oct 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

3.5L V6 engine 2006 Dodge Magnum smoke and liquid bubbling out of white container under the hood?


usually means hot gases from the combustion chamber are leaking into the coolant passages in the engine block via a bad head gasket

Jul 13, 2014 | Cars & Trucks

1 Answer

2006 cobalt wipers dont move. but the moto is running, so how do i get to the wiper rod or motor section to tighten nuts or replace motor at please! please send a pictures etc. too me too. thankyou..


Hello
I would first try to tighten the wiper arms first where the arms bolt to the rods at the cowl remove the plastic caps and tighten the 13mm nuts that hold them down then you might need to adjust them if they wipe past the windshield
Good luck
Chris

Mar 22, 2011 | 2006 Chevrolet Cobalt

1 Answer

I poured bug washer liquid in my temperature gauge. What could happen to my car? The bug washer liquid is pink. I wasn't looking and there was another container that had a pinkish looking liquid...


The worst that could happen is that BUG liquid is not ANTI-FREEZE... and in the worst cast scenario is that your COOLANT will FREEZE in cold temperature. I dont know the chemical composition of the Bug Liquid but my guess is, that its mostly water. If your coolant tank is not overfilled I would tryin to add - pure anti-free NOT the 50/50... If you can add you can still add the same quantity of ANTIFREEZE as the quantity of BUG liquid you added, you should be alright. That being said, neither I nor any mechanic is likely to know what will happen with the bug liquid at High Temperatures of the engine. This is more important if you are planning to keep this car for more than a few years. When you drive, keep an eye on the temperature of the engine, if you notice un-usually high temperature, that may be a sign that your bug liquid is RUINING the thermostat. But basically if you dont want to have this head-ache, go to your local mechanic, and tell him that you want your cooling system drained and FLUSHED. (and Refilled with ANTI-FREEZE properly mixed) You dont want to find out what happens when WATER FREEZEs inside the engine. What Happens When the water freezes? IT EXPANDS, and you dont want that. Unless you are planning to buy a new engine. If this was helpful PLEASE leave feedback. Thanks

Dec 17, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

Car is overheating with steam coming out of the coolant cap of the coolant container.


there is a problem with the radiator as it gets more hot due to blocking of net inside it.get the radiator serviced and use proper coolant liquid.

Dec 03, 2009 | 2006 Chrysler Pacifica

1 Answer

Looking at buying a 2nd hand kymco 250 hawk, 26000km . Any particular areas to look at?


the controls and the front suspension see if it does not make noise and finaly the rear chain link see if its not bent

Oct 26, 2009 | 2005 Kymco Xciting 250

2 Answers

Front Windsheild Wipers


I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal
  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Apr 09, 2009 | 2006 Ford Freestar

1 Answer

Cleaning


A bucket for soapy water Soap or liquid detergent; automotive cleaners will work Gloves (to keep your hands clean) Bug and tar remover Degreaser and/or engine cleaner A toothbrush WD40 A brush for wheel cleaning Wheel cleaner At least two microfiber or 100% cotton sponges A variety of soft cotton towels and more abrasive rags A chamois cloth for drying

Nov 10, 2008 | 2005 Kymco Yup 250

1 Answer

Cleaning


A bucket for soapy water Soap or liquid detergent; automotive cleaners will work Gloves (to keep your hands clean) Bug and tar remover Degreaser and/or engine cleaner A toothbrush WD40 A brush for wheel cleaning Wheel cleaner At least two microfiber or 100% cotton sponges A variety of soft cotton towels and more abrasive rags A chamois cloth for drying

Nov 10, 2008 | 2005 Kymco Grand Dink 250

1 Answer

Linux


A shell script is a plain text file that contains instructions for a Unix style shell to run. The most common shell on Linux is BASH.

e.g. a minimal example

#!/bin/bash
# script that says hullo
echo "Hullo world"


(you would normally do _much_ more than that.)

By the way most Linux distros have easy to use tools to set up modems (dialup and pppoe). Or you can usually access the modem/ADSL router directly through a web interface. (see the documentation that comes wioth your modem. (you wont need those silly disks you got with your ISP account :)

Jun 30, 2008 | Computers & Internet

Not finding what you are looking for?
2005 Kymco Xciting 250 Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...