Question about 2001 Suzuki VS 800 Intruder

1 Answer

Think i had water get into my gas tank and i would like to drain gas tank but can not find gas line, can i get a diagram of the gas line?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 232 Answers

The best way to get the tank line out is to lift your seat , unbolt the bolt at the base of the tank and lift the tank while pulling it backwards . you than will notice the gas line to your carby .

Posted on Sep 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What problems can take place if i put watered down gas in my oldsmobile araura


Should not have caused significant damage. Change the oil and check again after a few days.

Aug 10, 2017 | Oldsmobile Aurora Cars & Trucks

1 Answer

I might have sugar or water in gas.


This is a Saturn ion i do not think there is and i would not even start this car if you even think there may be sugar in the tank,Water can cause a little damage but not really as long as there is gas mixed but still do not run engine. sugar is bad!!. this will cause lots of damage. converter, injectors and cylinder wall damage.
You will need to drop tank and drain it out and then flush it out good. then drain fuel lines and replace the fuel filter. after you are done i would put in a bottle of dry gas and a fuel injector cleaner additive in the tank.
Note ' make sure to flush tank good, When fuel lines are removed the fuel in lines should drain back out of lines. the only problem is what is in the fuel rail and injectors, this is why i said to add injector cleaner and dry gas additive to help if there is any small amount of water left in tank. hope this helps ,good luck.

Apr 30, 2012 | 2003 Saturn ION

1 Answer

Water in gas tank


will need to completely drain tank, either remove tank from car or if has an external electric fuel pump you can disconnect fuel line between pump and engine, connect 12v battery to power supply of pump and pump gas out. make sure to run line to bucket to collect gas/water mix, remember water is heavier that gas so water will be on bottom of tank and first to pump out

Feb 05, 2012 | 1989 Mercury Grand Marquis

1 Answer

We noticed water beginning to mist out of what appears to be the supply line (the braided line, not the copper line). That same braided line is connected to the line in the wall...and the top of the water...


If you can shut the cold water off at the water heater you should not have to turn the water off outside. Drain hot water from taps at lowest point in house, hook a hose up to boiler drain at base of WH and drain some water from here. Do as you stated and shut gas off to be safe. Change supply line.
RJ

Jan 08, 2011 | General Electric GE SmartWater Household...

1 Answer

What to do found water in gas tank of pressure


have you drained the tank, and disconnected the fuel lines from the carb. so that the carb will drain? if not you need to get the water out of the carb. the put some rubbing alcohol in the new gas and this should get rid of any residual H2O

Apr 17, 2010 | Karcher 2500 PSI Pressure Washer

1 Answer

Water drain leaking gas. I have a 1996 gsx r750T.


Soldering (with an iron) is pretty safe, but I can't recommend it. You'd probably need a torch to get the surface hot enough for the solder to stick.

How about epoxy? JB Weld is petroleum resistant... There are sll sorts of testimonials where people used JB Weld to repair gas tanks.

Charlie

P.S. I couldn't access the diagram you included.

Aug 25, 2009 | 1996 Suzuki GSX-R 750 T

1 Answer

I got water in my XJ8 fuel tank. How do I drain the gas?


Hi j the tank would have to be removed as there is a filter on the pump and dirt will be in there two D

Nov 22, 2008 | 1998 Jaguar XJ8L

Not finding what you are looking for?
2001 Suzuki VS 800 Intruder Logo

Related Topics:

432 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4995 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...