Question about 1991 Yamaha FZR 600

1 Answer

Where to put loose oil hose back in the right place, oil hose is hanging under neath the gas tank can not find where to connect it too

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

What makes you think its an oil hose? look at the bottom of the tank and make sure its not a drain or vent tube for the gas tank.

Posted on Sep 25, 2009

  • ronbond May 08, 2011

    i am having the same issue.. i have three black rubber tubes hanging at the bottom of the gas tank.. one is leaking oil an one is leaking gas an the other is a smaller gas tube.. where do they go?.. same issue with the same bike.. grrrrr.. lol

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2013 Dutchman Infinity 3640 rl. How do I drain one of the grey water tanks?


U SHOULD HAVE A BLACK TANK AND A GRAY. TOWARDS THE BACK WERE U HOOK UP THE HOSE FOR DUMPING U WILL SEE TWO LEVERS ONE IS FOR BLACK ONE IS FOR GRAY. AND IF UR TALKING ABOUT FRESH HOLDING TANK LOOK UNDER NEATH AND U SHOULD SEE A PLASTIC NOSEL WITH A TURN VALVE LIKE WHAT BOX WINE HAS TO PURE A GLASS

May 26, 2015 | RVs

3 Answers

Slow fill gas tank


either fluid is in the vent hose or the fill hose is pinched off somewhere under the car.. mechanic/tech can use an air hose to check for blockage

Apr 11, 2014 | 2000 Hyundai Elantra

1 Answer

Engine starts for two minutes then shuts down


THE HOSE MAY BE A GAS FLOW HOSE OR BLEEDER. IT COULD BE YOUR SPARK PLUGS IS DIRTY AN IN THAT CASE IT WILL NOT ALLOWE IT TO BURN GAS IT WILL CAUSE IT TO CHOKE .ARE IF THAT DONT WORK DRAIN ALL THE GAS AND MAKE SURE THAT YOU HAVE A OLD RAG AND A SCREW DRIVER ARE SOME SORT STICK THE RAG IN THE TANK AFTER DRAINING THE GAS AND CLEAN THAT TANK REAL GOOD AND REMEMBER DRAIN YOUR CUP THATS HOOKED AND THE CARBORATER THAT SHOULD BE ONE SCREW THAT HOLD THE CUP IN PLACE THEN YOU HAVE A LITTLE SMALL CUP THAT IS REALLY CALLED A FILTER MAKE SURE THAT THE OLD GAS IS OUT ALSO. PUT FRESH GAS IN IT AND IT SHOULD FIRE RIGHT UP

Dec 18, 2012 | Honda Black Max 3000 Psi Pressure Washer

1 Answer

What is the procedure for draining the gas out of the tank to change the fuel pump


ok..

  • remove the negative battery terminal
  • open the gas lid and remove the tank cover.
  • under the car , under the gas tank is a drain valve , Its like a bolt)
  • connect a running hose and let water flow under the car, (optional)
  • get a large flat container
  • remove the drain valve from the tank and let the gas run out into the container. when its almost full cover back the valve, empty the container in a gas container an then continue to drain.

easier method but most people say its unsafe,

you need a hose and a gas container,

  1. pop the hood,
  2. locate the gas filter
  3. remove the hose leading to the gas filter, put it in your hose and place the other end in the gas container (ITS LIKE YOUR extending the hose to your gas container instead of the filter.
  4. turn on the ignition and watch the gas pump out the tank to your container, (pump must be working for this to work)

Apr 02, 2011 | Buick Regal Cars & Trucks

1 Answer

My 385xp-husqvarna chainsaw with a 2 foot bar is leaking oil. I cut wood with it last saturday and woke up sunday morning to find a puddle of bar oil under neath of it. This has been a reaccuring event. ...


Husqvarna are reknown for this, remove the pump and pick up pipe with the filter on, slip a rubber o ring the correct size onto the hose, this will space the hose out the distance of the o ring and create a better seal against the oil pump body.
Fill the tank with petrol, this is much thinner than chain oil so you should very quickly see where the leak is.

Dec 04, 2010 | Husqvarna Craftsman 36cc, 16 In. Gas Chain...

2 Answers

I need the location on where the fuel filter is located on a 1998 dodge caravan sport 3.3L flex fuel.


I believe the fuel filter is under the vehicle and over the fuel tank. You'll have to drop the tank to access the filter. Loosen the nut on both ends of the filter and gently seperate. Replace new filter and retighten the nuts. Secure the tank back.

Put a jack (for a flat tire) under the fuel tank, so you could control how far it dropped. Then remove the two screws that hold the fuel tank straps. The screws come out, the fuel tank is loose, lower the tank by lowering the jack. Now it is easy to reach the filter. One screw holds it in place. Unscrew it, it comes right out. The tricky part is figuring out how to unplug the fuel lines. Look at the replacement filter, note how the plastic piece inside each fuel line has to be squeezed to remove it. You need to squeeze the old ones the same way to release them. It isn't easy. Squeeze the plastic piece that is holding the hose in place until you can work it out. A few drops of gas will dribble out. The gas is NOT pressurized. Unsnap the old hoses, snap in the new ones (much easier). Screw the new filter into place. Jack the fuel tank back into place. Screw the straps back on. Clip the ground strap in place where the old one was. You're done.

Aug 03, 2010 | Dodge Caravan Cars & Trucks

2 Answers

Problem: I think my fuel line came loose and I'm not sure where it goes. It's the small hose coming from the gas tank and then just goes down somewhere..?? I found it hanging after I had filled up. Is this...


This is a vent hose, it should run from the tank down inside the frame. Most times they are a clear hose but not always. It is to let the fuel tank breath, or it will cause a vacuum as fuel is used up by the engine and the tank being closed off.

Jan 28, 2010 | Honda VT 750 DC Shadow Spirit Motorcycles

1 Answer

WHERE IS THE FUEL FILTER LOCATED ON A 1999 DODGE,CARAVAN?


The filter is tucked in over the fuel tank. Here's how I replaced mine... I put a jack (for a flat tire) under the fuel tank, so I could control how far it dropped. Then I removed the two screws that hold the fuel tank straps. The screws come out, the fuel tank is loose, lower the tank by lowering the jack. Now it is easy to reach the filter. One screw holds it in place. Unscrew it, it comes right out. The tricky part is figuring out how to unplug the fuel lines. Look at the replacement filter, note how the plastic piece inside each fuel line has to be squeezed to remove it. You need to squeeze the old ones the same way to release them. It isn't easy. Squeeze the plastic piece that is holding the hose in place until you can work it out. A few drops of gas will dribble out. The gas is NOT pressurized. Unsnap the old hoses, snap in the new ones (much easier). Screw the new filter into place. Jack the fuel tank back into place. Screw the straps back on. Clip the ground strap in place where the old one was. You're done.
SOLUTION COURTESY OF WIKIANSWERS.COM

Jun 04, 2009 | 1999 Dodge Grand Caravan

1 Answer

Chevy s-10 fuel system


Sounds like the tank vent is plugged. This is generaly a pipe or hose on the filler neck of the gas tank. Pulling the hose on the canister is allow the air to escape there instead of the filler neck.

Jul 29, 2008 | 2003 Chevrolet S-10

1 Answer

98 Lincoln Continental - Fueling problem


I found the problem!!! There is a square steel box under a plastic cover under the gas tank. This box is to filter the gas fumes that comes out of the gas tank when filling. Well the hose from the filler neck (or tank) fell off and was hanging there. I put the hose back on (very easy) and that was that, no more problem! I talked to so many people and mechanics and no one knew about this problem. I suffered with this for so long!. So do it yourself and save a ton I'm sure.

Jun 29, 2008 | 1998 Lincoln Continental

Not finding what you are looking for?
1991 Yamaha FZR 600 Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...