Question about 1999 Suzuki GSX-R 600

1 Answer

It will not start. Pulled the spark plugs, cleaned them, held the spark plug next to ground while I cranked the motor, no spark. It ran a few days ago. I did the same thing because its been sitting in the garage for a long time, and it fired up. Now it won't.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

3 thing cdi / magneto / coilcheck to see if you have power to the coil and cdi and get back to me

Posted on Sep 23, 2009

  • Laird Eastman
    Laird Eastman Nov 13, 2013


  • Laird Eastman
    Laird Eastman Nov 13, 2013

    and where is the magneto? I am new to this so you will have to explain more if you don't mind


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a dodge stratus 2000 with 2.4 liter dohc motor, ran fine then stalled once started right no spark will not start

Try using one of the old plugs and connect it to #1 and a good ground then try starting to visually confirm if spark is/is not present. Its much easier to see the spark in the dark. If you get a spark the problem is not electrical and could be a bad ground between the plug and the block, rarely happens, but not unheard of.

Feb 27, 2015 | 2000 Dodge Stratus

1 Answer

I have a 1993 mercury outboard with intermittent starting problems will work all right for a few days then won't start. If left sitting it eventually will start. Hauled it to repairman who had it for a...

Yellow Gell pack? Can you describe that a little more? Does it have red and yellow wires going to it? May be a cranking RPM issue but may be some underlying issues as well. Your mechanic, did he bring the yellow gel pack to your attention? Many things to check and I feel a reputable repair facility would be able to find the issue. I will try to help you as much as I can. Please get back to me.
Thank you, Lewis
Hot Headz Marine

Sep 22, 2013 | Boating

1 Answer

1992 ford ranger has fuel but no spark drove it parked it the next morning will not start

ave you pulled a plug wire off and cranked it to see if you are getting spark to the plugs? That would be where I would start.

Dec 30, 2011 | Ace Hardware Electrical Supplies

1 Answer

98 Ford F150 w/4.6l Wont start. Hear fuel pump click. Have pressure on fuel rail. Pulled #1 plug from head and plugged back into wire. Grounded plug and cranked. No spark. Changed wires 4 and 7 four days...

have diagnostic codes checked to see if you have a cam or crank sensor fault. make sure fuel pressure is at the required pressure, just testing to see if you have fuel at the valve is not enough. replace all spark plug wires. if you replaced two then all are just as old and even when they "look good" does not qualify as "they are good". Replace coil pack. start up drive away happy

Sep 05, 2011 | 1998 Ford F150 Regular Cab

2 Answers

Out 2003 chevy cavilier 2.2L its not the flex fuel. The other day I went out to start it and it took a little while but when it did start it ran rough. I pulled the coil pack out and held spark plugs in...

I would suggest you go through your entire ignition system. I would start with rechecking the 2 dead plugs for spark. Check all your plug wires for ware and damage check the plugs themselves. The induction wire and im not sure but if you have a distributor check the cap. If you go through the entire spark system and it is getting a good spark you might want to start checking out the engine itself.

Jul 29, 2011 | 2003 Chevrolet Cavalier

1 Answer

85 ranger, engine cranks but won't start. Fuel ok, no spark during crank, sparks at end of crank. 2 weeks ago I replaced the intake manifold gasket and starter, it started right up. The vaccum was at 20...

Sounds more like an electrical problem.First I'd check the battery voltage, should be at least 13. It shouldn't drop much below 11 when you crank the engine and it should bounce back when you stop. Make sure your connections are good especially to the coil,wires aren't frayed or loose on connectors. There should be a ground from the body to the motor. Is it still thereand making good contact? If I'm not mistaken the coil should ground to the motor, make sure it has good contact as well. Also double check your connections at the starter to make sure they are clean and tight. Loose connections can draw extra power and could draw enough extra power to kill the coil. Hope this helps.

Jul 03, 2009 | 1985 Ford Ranger

1 Answer

1993 Jeep Grand Cherokee engine problem

If the crank sensor (reaR at bellhousing) is dirty, will not start, clean up and visually inspect

Apr 27, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1998 Cavalier No Spark in cylinders 1 & 4

ignition mod. grounds,pcm or timing belt could all be it but, I would have to look at timing first.

Jan 13, 2009 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
1999 Suzuki GSX-R 600 Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

75051 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides