Question about 2006 Harley Davidson FLHRI Road King

1 Answer

2006 road king custom w/siren security system - speedometer, oddometer, horn, signal lights, brake lights do not work. dash panel doesn't light up but small red security key stays on. also the button on side of dash when pressed lights up an shows mileage but mileage stays the same. other than this the bike runs fine. I checked the fuses and they seemed to be ok

Posted by on

  • bulldogchief
    bulldogchief May 11, 2010

    Take a look at the voltage regulator.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 14,161 Answers

Posted on Jun 25, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 190 Answers

SOURCE: lighted floor board inserts inop

was the Y connector used with resistor

if not need a resistor in the circuit to cut down current possible led's are dead an need to replace

here's a how to make your own led tree

Posted on Apr 06, 2009

tundrajet
  • 80 Answers

SOURCE: Speedo, turn signals, brake lights, horn stopped working. All else is fine.

Gap your plugs to 38 thou. Check all your bulbs (one burned out will affect the rest) Take a look at all your fuses and make sure they are all ok. Otherwise you are probably looking at a wiring short which will require trouble shooting of the elctrical system. Buy your self a service manual for your bike, this will help you a lot.

Posted on Jun 06, 2009

  • 69 Answers

SOURCE: can i bypass the security system on a 2005 road

If you do not have the key fob that came with the bike (security system) then go to a dealer to have them reset it and get the key fob for it

Posted on Jul 26, 2009

  • 124 Answers

SOURCE: 2002 road king horn wiring were due both leads connect to

I am assuming you mean what are the color of the wires that go to the horn. If so, the yellow/black is positive when the horn button is depressed and the black is ground. The wiring for the horn button is orange/white positive and yellow/black to horn. The orange/white wire gets 12vdc from the acc fuse.

Posted on Nov 25, 2009

  • 623 Answers

SOURCE: I have a 05 road king custom, Im doing my forst

The filters should be the same.
Make sure you have a new o-ring for the oil plug.
Make sure you properly ID the oil plug, there are two under there, one is oil, other is trans.
Don't overfill oil.
Don't over-tighten oil plug on re-installation, the aluminum threads are notorious for pulling out. Oil ring does the seal, snugly tight, don't put all you have into it.

Posted on May 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 Harley Road King Custom. With ignition switch on, I have horn, brake lights and instrument light. I don't hear fuel pump, turn signals don't work; headlight doesn't work and


Hi Mark, I would start by checking fuses first located behind the left side panel. Then check for continuity at your system/fuel pump relay also in that same general area, check the connection at the turn signal module and for continuity at the ignition switch and your high/low beam switch. This is assuming of course that your security alarm has been disabled. for more information on your question please visit the websites below and good luck:
Harley Davidson Wiring Diagrams and Schematics
Harley Diagnostic Codes 04 to Present

Dec 10, 2012 | 2005 Harley Davidson FLHRS - FLHRSI Road...

1 Answer

The tail lights have started staying in brake mode, turn signals not working properly. Some times when you hit a bad spot in the road the tach and speedometer stop working as well as the head lights. I...


Could be bad brake light switch but turn signals involved so? Has to be bad ground.Light sockets corroded bad wiring thru fender mounting bolts in tail light assembly broke but corroded in place,not a good ground.Has to be simple cause bike runs.

Mar 09, 2010 | 2001 Harley Davidson FLHR - FLHRCI Road...

2 Answers

My alarm on my 02 harley road king goes off when i come to a stop. it stops when i take off. replaced battery and still same problem


If your meaning the siren is making noise, I would think you may have a bad TSSM unit. If your security light in the speedo is coming on, you may just have a turn signal issue, maybe a bad HD brake run turn modual (if you have added this to the rear) or if you have a Kuryakyn Panacea or run turn brake. These add on components commonly cause TSSM codes to pop up and will present with a Security light in the speedo. Plus your signals will blink rapidly 5 times as an additional warning.

Jul 07, 2009 | Harley Davidson Harley-Davidson FLHR Road...

2 Answers

Speedo, turn signals, brake lights, horn stopped working. All else is fine.


Gap your plugs to 38 thou. Check all your bulbs (one burned out will affect the rest) Take a look at all your fuses and make sure they are all ok. Otherwise you are probably looking at a wiring short which will require trouble shooting of the elctrical system. Buy your self a service manual for your bike, this will help you a lot.

Jun 03, 2009 | 2005 Harley Davidson XL 1200 C Sportster...

2 Answers

I have a 2003 road king that the break lights don't work when I press the breaks either on the break pedal or on the handle bars.


Check your brake selenoid, which should have a electric connection. This connection sends a signal to the brake light selenoid that the brakes are being applied there by turning the brakes lights on.

Jan 23, 2009 | 2006 Harley Davidson FLHR Road king

Not finding what you are looking for?
2006 Harley Davidson FLHRI Road King Logo

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...