Question about 1997 kawasaki GPZ 500 S - GPX 500 R

1 Answer

No spark on bike

No spark on my kawaski gpz 500 put new spark plugs on and new coils still no spark what could it be ?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Fuse or lose wire but sometimes stator

Posted on Sep 20, 2009

Testimonial: "thanks for the help very useful thank yoy"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1985 kawasaki gpz 1100 has no spark and wont start ?


Perhaps a few things to check would be
start switch, spark plug, spark plug cap, ignition coil, ignition lead

Apr 30, 2014 | kawasaki Motorcycles

1 Answer

1995 Kawasaki GPZ 1100 no spark


Hi, Davidalan and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting/leaking, spark plug cable connections loose check for spark leakage in the dark.
6. Faulty ignition coil or electronic control module.
7. Faulty pulse coil.
8. Faulty CKP, CMP, or BAS sensor.
9. Faulty ignition switch.
10. Tilt sensor needs a reset.
11. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
96 GPZ1100 no spark
1984 Kawa GPZ 1100 NO SPARK
Kawasaki GPZ1100 KZ1100R 1988 Service Repair Manual Download Manuals... $15
OEM Parts for Kawasaki
1995 Kawasaki GPZ1100 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Oct 17, 2017 | 1995 kawasaki GPZ 1100

1 Answer

My motorcycle doesnt start , it's sending no power to the spark plug what could it be


disconnect a positive wire going to one of the coils and put a paper clip in it,put it on metal and crank the bike to see if it sparks, we can then go on from there.

thanks

Mar 21, 2011 | 1986 kawasaki GPz 1000 RX

1 Answer

1998 kawaski jet ski that boggs down on take off


Sounds like this bike sat for a while. When carburetors sit, the jet's inner diameter shrinks slightly from oxidization/micro-corrosion, and the diameter of the needles that go through them grows for the same reason.

Replace the jets and the needles that go through them.

I had this problem with a Suzuki GS850. When I fixed it, I treated the bike as I had been before I fixed it on the test drive, and almost launched myself off the back of the bike when I first opened the throttle. Careful.

Jul 08, 2010 | 1998 kawasaki GPZ 1100

1 Answer

What is the spark plug gap for a kawasaki ke100 1975


.35plug gap .. points .12 to .17 or a match book cover is around 13+14 1000s of an inch ,,cdi pick up coil gap .30 should be fine

Jul 05, 2010 | 1987 kawasaki GPZ 500 S - GPX 500 R

1 Answer

I have a W reg 2000 kawasaki GPZ 500 s, with an eletrical fault. I was told it was probably the wiring or the generator, so I put a second hand wiring loom on it but it still wouldn't work, so I bought...


do you have a circuit diagram. have you traced the system through. Sounds to me like it is an issue before all that, either with the junction box or IC igniter. The stop switch could also be an issue as could the ignition switch. Keep posting if you want me to have a closer look at my wiring diagram

Mar 06, 2010 | 2000 kawasaki GPZ 500 S - GPX 500 R

1 Answer

2000 Kawasaki GPZ 500 S will not start


Hi, Hgv and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Quick disconnect check ball stuck.
14. Compression below 75 PSI.
15. A stuck-bent-burnt valve.
16. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
17. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
18. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
19. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections are loose or connected to the wrong cylinders.
20. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
21. Faulty neutral, clutch, kickstand safety switch.
22. Faulty fuel pump or fuse or relay.
23. Faulty or corroded run/stop switch.
24. Tilt sensor needs a reset.
25. Security system not disarming alarm needs a reset.
26. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
gpz500s wont start help
What to do When Your Motorcycle Won Start
http://service.tanga-moteurs.ro/data/Kawasaki_EX500-GPZ500S_1987-1993-ServiceManual_%28EN%29.pdf
OEM Parts for Kawasaki
http://mybikemanuals.com/kawasaki

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 05, 2009 | 2000 kawasaki GPZ 500 S - GPX 500 R

1 Answer

Kawazaki gpz carbs will fire when you put petrol directlt in them


Check the routing of the wires under the tank. Also check the wire connections. It sounds like the installation of the tank is pulling on the wires causing a momentary disconnection of a power wire.
Alternate to that, are the spark plug wires grounding against the tank?

Please rate this solution. Thanks!

Mar 28, 2009 | 1996 kawasaki GPZ 500 S - GPX 500 R

Not finding what you are looking for?
1997 kawasaki GPZ 500 S - GPX 500 R Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5055 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...