Question about 2000 Yamaha DT 125 R

1 Answer

No spark glass tube behind head light broken - 2000 Yamaha DT 125 R

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 921 Answers

When replacing these bulbs take extra care to not tough them with your bare hands....all halogens are like this..... even for cars.
where gloves or clean you hands real good to get the oils off of them.

Posted on Sep 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Preamp tubes for XXX amp. How do I choose, and can I replace myself?


Replace with like part numbers... 12AX7's and 12AT7's are common numbers. Unless the tubes have failed heaters, do NOT expect much if any improvement. If the tubes are microphonic and lightly tapping on them produces major noise that would be a reason to replace. Try to avoid getting skin oils on the glass of tubes when replacing.

May 15, 2011 | Peavey Butcher Guitar Amplifier Head (100...

1 Answer

My 2006 sts has water inside the headlight. what can i fix it


check the head light glass that it is not cracked, or the seal around the glass is broken, and if the the silver reflector,
is water damaged, it needs to be replaced.

Oct 28, 2010 | 2006 Cadillac STS

1 Answer

My 1967 fender super reverb amp starts popping and cutting out on high volume after it's played for about 15 minutes.The 2 6L6GC tubes flicker a soft blue light while this is happening. If you turn down...


IF the blue is on the GLASS envelope, that is just phosphouresence in the glass and not a problem. The harder you drive the tube, the brighter this will get. The electron beam heading toward the plat of the tube leaks past the plate and hits the glass. ot to worry if the blue is on the glass.

IF the glow is magenta/purple in between the internal electrodes, the tubes have gotten gassy and need replacing.

From your desciption, I would suspect a capacitor is going bad someplace in the unit OR the vibration has loosened a connection someplace. Input jacks are VERY common problem for intermittent noises like this. The jacks get destroyed because the musicians FAIL to restrain the intrument cables and yank them sideways. Loop the cable through the handle to help avoid the problem.

Jan 31, 2010 | Music

1 Answer

Tv wont turn on


It does sound like the lamp is your problem. You can remove it and inspect it visually for obvious signs of failure. Usually you will see that the arc tube, the glass tube down the center of the lamp, has shattered. Clean out the broken glass from the lamp compartment carefully before replacing the lamp.
Good luck.

Nov 28, 2009 | Sony Grand WEGA KDF-50WE655 50" Rear...

1 Answer

Older Faema double head. Power light on, but


It is on the right side of the machine behind the grouphead if you remove the top panel you will see te box with the red switch sticking out. MAKE SURE THERE IS WATER IN THE MACHINE FIRST!!!!!! Do not trust the sight glass, if the level probe is in there, turn machine to 1 then disconnect the electrical connector on the side of the sight glass, the pump should kick in and water will flow in the boiler, if the level does not increase in the glass, then the machine turned itself off because the element got too hot from lack of water. The hole for the sight glass is blocked.

Jul 31, 2009 | Coffee Makers & Espresso Machines

1 Answer

When I turn on the tv, the screen is black with a thin strip of light. It has voice, but no picture


Hi is it a glass tube or a LCD/Plasma? If its a glass tube CRT the frame circuit has broken and may need the frame chip changing that means that the set Will have to be open from the back and the part/s removed and new ones soldered in

Jul 30, 2009 | Sansui DTV2760 27" TV

1 Answer

Condenser keeps icing over


Hi: I'm assuming you are talking about the evaporator. In the back panel of the freezer. Usually this is the defrost heater. It's at the bottom back of the freezer behind the metal panel. Inspect the glass tube and see if the wire inside is broken (like a light bulb filament.) If so replace it and all will be well. If that isn't it replace the defrost timer. The schematics will be available at sears parts. I hope this helps, Jeff

Jun 08, 2009 | Frigidaire FRS266ZDSB Side by Side...

1 Answer

Oil leaking into sparkplug chamber


thread dammaged in head causing spark pug to come loose can fit heli coil to fix thread in head so spark plug wont come loose and leak oil into tube. other places oil can come from to cover plug in oil
remove rocker cover then remove spark plug tube they are screwed into head and clean thread of tube and apply sealant loctite to thread refit to head and may pay to replace seal for top of spark plug tube that is in rocker cover
one of these or both can leak, if tube is tight in head it may not be leaking the top seal is

Jun 04, 2009 | 1993 Isuzu Rodeo

2 Answers

How to change a headlight bulb on a 1999 dodge avenger?


You have to open the hood and go at it from behind the bulb. look behind the light fixture set up and you will see where the light bulb goes. Simply twist off and pull out. the old light bulb will com out also.

Apr 14, 2009 | 1999 Dodge Avenger

Not finding what you are looking for?
2000 Yamaha DT 125 R Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...