Question about 2008 Yamaha Yamaha G5

1 Answer

Stalls at stop signs

Every time I stop the Vino Classic 50 stalls out - I have to hold the front brake and hit the electric starter with my thumb while giving it almost full throttle to get it to start again and that's too much for the front brake so it throws me into traffic

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Remove and clean the carburetor. The problem is a plugged or partially plugged idle jet. There should be a throttle screw and an air screw on the side of the carb. The big screw is the throttle screw. Remove both screws and the float bowl and spray carb cleaner in all the holes and screens and jets to clean out the plug. Use goggles to avoid spray kicking back into your eyes. Put the two screws back in the hole each one came from and then turn them clockwise ubtil they LIGHTLY seat. Now open each of them one and one half turns.

Posted on Sep 12, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2007 Chevy Aveo stalls at lights and stop signs. I had the 2 sensors related to the timing replaced, the throttle box replaced, and a new coil, all in the past month, but nothing has changed.

a simple test here is to idle the car, and put your foot on the brake
if it stalls then the problem is a faulty brake booster
every body sits at lights /stop signs with their foot on the brake not realizing it and miss that bit of evidence in determining a problem
check for vacuum leaks ( transmission actuator hose, vent controls) run fault codes to see if there are problem sensors

Nov 29, 2016 | Chevrolet Aveo Cars & Trucks

2 Answers

What makes my 2007 Isuzu turn off when I come to a stop

if it is petrol and you have your foot on the brake do a simple test first of stopping with the hand brake and if it keeps idling the replace the brake booster
next is to run the fault codes

Jul 09, 2015 | Isuzu Cars & Trucks

2 Answers

My Suzuki carry van cuts out when you stop and starts straight away have had it put on a diagnostic but shows nothing

no year,
no country
no engine stated, (a hard nut to crack)
we (usa forum) do not have Carry here, so.. that is a problem.
UK usage of "straight way": i see.
so this is called 1 of 2 things
engine stalls?
or engine misfires, or both.
Many engines, (ours) have this thing called EGR.
and if it sticks it stalls on ours. it closes just as you stop
so if it dont, it will stall. (we clean it and it works , if lucky)

as is never getting a tuneup and spark is (uk;dodgy)
there are 50 causes for stalls(most inside engine proper)
the classic 3 ways.
  1. bad engine bad, or cant breath or egr stuck open or cat melted.
  2. bad spark. (tune up time, mate?)
  3. EFI sensors read wrong, so fueling is bad. or fuel pressure is weak.
in all cases we use tools to find it , after the 100k meter, service tuneup is done.
tools as in meters and gauges, (spanners are a given)

signed blooody yank

Mar 16, 2015 | Suzuki Cars & Trucks

1 Answer

99 cherokee 4.ol stalls when coming to stop with ac on

but if you hold your foot on the throttle i t dont
that means the ISC idle speed controls are failing
or vacuum air leaks. (lean)
or too lean for any reasons.

there are 50 ways to get a stall
even the classic and simple do a tuneup.

Aug 31, 2014 | Jeep Cherokee Cars & Trucks

1 Answer

Online chat

If you have the foot on the brake when stopping and it stalls , try slowing down and stopping on the hand brake to see if the engine stalls . If it doesn't stall on the hand brake then I would suspect a leak in the brake booster that is affecting the engine by letting air into the manifold through the activated booster. If there is no difference have the fault codes read as there may be a missing/ faulty vacuum line connected to a actuator in the gear box.

Mar 10, 2014 | Nissan Cars & Trucks

1 Answer

Anti theft reset ignition

some cars , you must hold the brake to start. did you read the operators manual yet, if not , why not??????
park lockout. (takes brake foot to release)
doesnt start, there are 3 phase,
cranks does it? crank at 250rpm , fast and robust, does it
starts, does it? (your burning fuel now....)
sustains running, (if stalls in 2 seconds that is IMMO cutting out fuel)
stalls means it was running and it stalled, RPM is 0
post the true symptoms and stop guessing at parts, there are 3000 parts, where will that end?

Jan 21, 2014 | 2003 Toyota Corolla

1 Answer

2001 grand vitara runs good but stalls every time I hit the brake, I had a corroded positive terminal I replaced it and now I have this problem

stalls, there are 50 ways to stall a motor,
1: engine lost compression. (can do that hot, or over heated)
2: lost spark.
3: bad fueling. (too much or too little)
4: isc sticks (can your right foot avoid the stall easy, bingo ISC.
5: lost electric power to EFI system. lost 12v, (even a loose fuse)

sounds to me #5 based just on the brake deal.

Sep 20, 2013 | 2001 Suzuki Grand Vitara

1 Answer

1999 Jeep Grand Cherokee Stalls and engine lite comes on

that is called engine stalling
all car when the engine stalled, the braking assest (helper) goes
dead. (loss of engine vacuum is cause, and is normal in all stalls)
we had to learn this in driving school in 1960, due to stalls then
are COMMON as nails, but the brakes still work. and ONLY takes more pressure with your foot ,
top cause of all stalls (and in 1960) is not getting a tuneup
ALL cars do this if you IGNORED basic SERVICE.
The ENGINE light came on
that means "get the car serviced," if you have tools it means
to a real shop SCAN it.
way ask blind web bunnies, this, we can diagnose your car,
or force you go get it serviced,
stalls have over 50 causes, a tuneup is top of list since 1884.
That old car in France sill runs and is serviced,proper.

try not to assume things, like pump or anything on car
can not be intermittent, (in fact assume it can and win)
get the car serviced
the operators guide, open it ? see the CHECK engine lamp page
see what it

Mar 18, 2017 | 1999 Jeep Grand Cherokee

1 Answer

Car stalls at stop signs

will it re-start right back up?
next time try to keep your foot on the gas pedal to see if it stay running ( be careful when you do this, if you give too much gas the car will over come the brake and cause accident )
if it stay running then you need to replace an idle air control valve

Mar 09, 2010 | 2000 Ford Taurus

2 Answers

1995 jaguar xj6 stalls once you stop at the stop signs

Look for an IAC sensor (motor) Idle Air Control.
Usually located on side & front of throttle body. Not 100% sure which type you'll have but if you have pintle type (pointed end) Remove it, spray it well with throttle body cleaner as well as port it came from, and retry. If it cures it temporarily & starts to do it again, replace it.

Aug 21, 2009 | 1995 Jaguar XJ6

Not finding what you are looking for?
2008 Yamaha Yamaha G5 Logo

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers


Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides