Question about Yamaha YZ 426 F Motorcycles

1 Answer

How much should it be to a rear suspension rebuilt or am i better off getting a new one.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 713 Answers

It can get fairly expensive to rebuild the rear suspension on bikes depending on what all is wrong with them. You can usually find aftermarket replacement parts for as cheap or cheaper than it would be to have it rebuilt.

Posted on Sep 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The car does not handle well when cornering at higher speeds, the car doesn't round the corner smoothly and feels unsafe, it is slightly better with the sport mode suspension turned on but still far from...

have a suspension specialist shop check the rear suspension bushes for failure
have the wheel alignment for the rear done as well
other items to check are wheel bearings , shock absorbers and body alignment ( possible accident damage )

Oct 19, 2017 | 2006 Porsche 911

1 Answer

Rear end rebuilt now ride is very hard

check for a kink in the air line to the bag or improper installation.

Oct 25, 2009 | 1998 Ford Expedition

1 Answer

1995 aurora need to replace front struts and rear shocks is it best to stay with air or is something else better also where is rear suspension compressor

I really like this car,almost bought one new. Now as you know OLD S has been gone since yours was made. No Parts at GM. Never were good in that area. I had a Caddy and did what you want to do when parts were avail. I stayed with the Air Strut/Shock from GM and adjusted ride height sensor ,then off to alignment. Compressor may be under battery,you'll hear it when you turn key on if it works. Kind of old to spend money on. I buy new and keep 17 years and do my own work for 46 years plus owned a shop a couple years. 15 years old is time to ride it out to the end.not restore it. Get a 68 Reviera for that. Forget the air if it becomes had to find parts or send yours out and have them rebuilt if they aren't rusted through.

Sep 29, 2009 | 1995 Oldsmobile Aurora

1 Answer


Front end pull when braking sounds like a brake problem. The rear problem is the large bushings on the trailing arm suspension. The car should coast more straight when there is no torque and then pull when there is torque. The rear axle is cocking to one side under load.

Aug 22, 2009 | 1993 Lincoln Mark VIII

2 Answers

The rear suspension

you need rebuilt or new air struts.their easy to change but you should have a lift it makes it very easy.

Aug 17, 2009 | 1993 Lincoln Continental

1 Answer

Buick Park Avenue rear suspension pump noise

You may have to replace it but money wise it is a lot of times cheaper to convert over to standard shock/strut suspension than it is to buy the pump

Aug 03, 2009 | 1996 Buick Park Avenue

2 Answers

1998 Dodge Ram 1500 Rear End problems

Hello, well you can look at it in a few different ways. Like you stated you can get a rear end from a salvage yard and not know what you are getting, you can spend some big bucks to get a new rear end, or you can get it rebuilt. I feel getting it rebuilt will be the better option. If you get it rebuilt you will have new parts in the rear end and know what you have verses the cost of a new rear end. This of course depends on how much damage there is in the rearend. Economically I feel that having it rebuilt is the best option. I always get nervouse when putting in any used part because you don't know what you are getting. If you do get it rebuilt make sure they put in new bearings which any reputible shop should anyways.

Mar 31, 2009 | 1998 Dodge Ram 1500 4WD

3 Answers

Recomende tire pressure touring motorcycle

Generally I put the front and rear tires @ 40 psi. You get better gas mileage , plus it rolls better when you have to push it around, but you also get better tire wear. I would set your rear air suspension around 12 -15 psi.

Mar 20, 2009 | Harley Davidson 2007 Harley-Davidson FLHX...

2 Answers

Rear air suspension

the air suppension has a lever on the rear axel
will want to check the lever and the sensor and make sure it hasnt come loose or bent and yes its adjustable. if it doesnt adjust you might have a bad sensor or air leak

Oct 29, 2008 | 2000 Lincoln Navigator

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

314 Answers


Level 2 Expert

281 Answers


Level 3 Expert

1214 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides