You said pads so is it disk brake in rear or drum ? disk have pads drums have shoes.
ok if its disk then its real easy to change them take tire off after raising car and theres two bolts at the back of the calibur one top and one bottom back those out then carefully slide the calbur off the disk ok then you will see two pads one inner and one outer they will look slightly different ok heres the short cut use the outer pad and place it agains the round center and use a large c clamp to press it flat then take it off ok know put new pads on and place it back on disk tighten the two bolts back in and put tire back on lower car know very important pop the hood and make sure the brake resivor lid is on good then get in car start it and pump brake back up dont miss that last step or you may not have brakes till you pump it up hope i have helped you.
SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working
Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
SOURCE: Radio says Secure on Nissan Almera Tino (04)
Your radio believes that it has been stolen out of the car since battery power was lost to it (as a result of the car battery going dead). There should be instructions in the user manual on how to reset the radio.
SOURCE: how to find the heater resistor for a nissan
the majority of heater resistors are on the heater box under the passenger ide of the dash, on some very few models it is part of the actual ac control panel
SOURCE: I have a 2003 Nissan almera tino 1.8SEV, the
which worning light if its the check engine light its possibly your fuel gas cap its loosing pressure
SOURCE: how do I remove the service spanner symbol from a
Try this: With the ignition ON but radio OFF, press in and hold the INFO button and turn volume control until the menu appears. Now choose CONFIRMATION and Enter. Go down and select SERVICE and press Enter. Select RESET and then Enter. Backup to the main menu and now turn ignition off. This should remove it.
861 views
Usually answered in minutes!
×