Question about Yamaha TZR 250 Motorcycles

1 Answer

CBR250RR wont start

I rode my CBR 250 RR earlier today and it was fine. Two hours later I went to start it and it wouldn't turn over, it would turn like the killswitch was on(but wasn't), then I left it and came back and it make a loud click sound then nothing. Then I tried again and it would click near the battery? I'm thinking the ingnition module? Help?? I don't have a cent to spare and I'm so upset.

Posted by on

  • corie lai Sep 11, 2009

    I pulled the tank off and the carby is holding fuel in the cylinders - don't know much about bikes but is this normal? I took the battery and charged it and took apart all the connections cleaned them and put them back together. Now it's not clicking at all, and no hill around unfortunately but tried on flat and just rattles at the back end (dropping the clutch in 1st). Battery is fine I think - maybe spark plugs? I have no idea? I so can't afford to get it repaired! Only recently the battery was getting buggered by a faulty regulator so it's only 12 months old. Any ideas? Thanks

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

Hi buddy you can bump it to get bikes going in 2-3gear just go down the hill and let the clutch out also the thing clicking is the starter solenoid buy one from ebay or some sort and replace this one

Posted on Sep 11, 2009

  • ollie reece-jones
    ollie reece-jones Sep 11, 2009

    HI BUDDY IN ORDER TO BUMP IT YOU NEED TO DO IT ON A HILLY AREA SO YOU GET SPEED TO TURN IT OVER AND PUT IT IN GEAR 3 AND WHEN YOUR UP TO 10 MPH LET THE CLUTCH OUT AND ALOS YES THE AIR FILLTER WILL BE HELD IN BY THE CARBS YOU NEED TO UNDO THE CLIPS HOLDING IT IN AND PULL IT OFF AND FIND THE REALY EITHER BANG IT OR GET A NEW ONE THERE NOT DEAR

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 cbr 600rr. new battery (5 months old) and all was working perfect. I was riding and got stuck in traffic moving slowly for about 10mins. I stalled it and it won't start. Gauges and...


the voltage of a normal battery
if it was running when checked it should have been 14.5-14.8 volts dc
have the battery checked using a load test meter

Apr 05, 2017 | 2003 Honda CBR 600 RR

1 Answer

I have a 1992 cbr 250 RR and the idle crew has crewed right out and im wondering were exactly it crews back in???


There is obviously only one place it can screw into. As a starting point, screw the idle screw in until it stops and unscrew it 2 1/2 turns. Your tick over can then be tuned.
Hope that helps

Dec 14, 2010 | 1992 Honda CBR 250 RR

1 Answer

The engine was starting and running fine but when I went to start next time engine backfires through exhaust and carbies and will not start


better check ur jets manlly air jets souns clogged up you might be getting bypass in pilot jets too easy fix

Feb 23, 2010 | 1996 Honda CBR 250 RR

2 Answers

My honda cbr250rr 1999 model wont start.. it


did you check the battery ? If the battery is bad it will do that also check the contacts to make sure they are clean and tight

Sep 02, 2009 | 1998 Honda CBR 250 RR

1 Answer

Honda cbr 400 rr starting problem


i could not find a schematic of a 96 cbr400rr, so guessing this bike is not from the USA. however, there should be a master fuse near the battery on the positive side mounted to the battery box somewhere. i would check this fuse first to see if its burned out.

also, is battery fully charged? might have to top charge the battery to get good juice if its old (>3 years) and been sitting for a bit.

good luck.

Jan 28, 2009 | 1996 Honda CBR 400 RR

3 Answers

CBR 250 not starting


Sound like you have a fuel problem.Turn the key without starting the bike listen for a slight buzzing noise it will come from where the end of the tank and the seat meet this is the fuel pump priming if you can not hear anything then most likely your fuel pump is not working.Your carbi may have grit in a jet a carbi cleaner can help.
I hope this helps!

Dec 08, 2008 | 1997 Honda CBR 250 RR

1 Answer

Cbr Speedometer Problem


It sounds like a loose connection in the wiring harness as you described moving wires around... either that, or there is some ferrous debris stuck to your speedo pickup. My dad''s VW wagon was throwing CEL codes that said the cam timing sensor was faulty. VW kept resetting the codes, saying this was normal. Three visits later, someone finally went and looked, and there was a piece of ferrous casting flash that had attached itself to the cam timing pickup (magnetic). Debris removed, no more CEL codes. Any inductive pickup like that will be thrown off if there is debris that has attached itself via magnetism. But the most obvious and likely culprit is loose wiring connections, as mentioned already.

Nov 20, 2008 | 1998 Honda CBR 250 RR

1 Answer

Medida para la regulacion de valvulas de honda cbr 250 rr


Hi,

Pls try referencing this page.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Nov 12, 2008 | 1990 Honda CBR 250 RR

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

379 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...