Question about 1996 Suzuki GSF 600 S Bandit

Open Question

My choke isnt workin on my bike is definatly the switch gear can anyone help?

Posted by on

  • 1 more comment 
  • gazzbazza26 Sep 10, 2009

    hey yes thankyou 4 ur respond, yes my lever wont come forward to activate the choke

  • gazzbazza26 Sep 10, 2009

    hey yes thankyou 4 ur respond, yes my lever wont come forward to activate the choke

  • yadayada
    yadayada May 11, 2010

    what do u mean about the switch gear? the choke is a cable operated by a lever

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix the choking on my 2008 Keeway Superlight?


If you put the choke on does it get better or worse,and have you checked the valve clearances are right.

Feb 22, 2015 | 2008 Keeway Superlight 125

2 Answers

On the right hand side of a kawasaki zxr750 h1 what is the black


Is your choke on when this happens? Using any kind of choke will cause the bike to rev higher than normal.

The knob that you can see protruding from one side of the bike is the idle control. If you've never messed with it before, there shouldn't be a need to seriously adjust it now, but that's not saying that someone else hasn't touched it.

Jul 22, 2010 | 1990 kawasaki ZXR 750

2 Answers

Is my choke on my 97 suzuki vz800. Supposed to be


You should be able to adjust the choke to where it will stay in without holding it by turning the rubber piece behind the choke clockwise towards you until the choke stays out on its own. You can adjust this so the choke automatically adjust as the bike warms.
Hope this helps..
Jeff

Apr 09, 2010 | 1997 Suzuki VZ 800 Marauder

1 Answer

My signal light isnt workin in the back but its workin on the side of the bike.


Start by checking the bulb has not blown,and is of correct wattage, about 3 - 5 watts, if no better check and clean the black earth wire coming from the indicator. Still no better then buy a multi-meter and check for 12v supply to indicator.

Feb 09, 2010 | 2001 kawasaki ZX-6R Ninja

1 Answer

Kdx 200 clutch not engaging properly


The clutch in your bike is a wet clutch. There is a lot of hyrdostatic friction even when the clutch is released completely. I think a large factor is the type, age and condition of oil. Perhaps something as simple as an oil change would help.

Jan 14, 2010 | 2005 kawasaki KDX 200

1 Answer

I have a 2005 kdx 200. bike starts and idles perfect, when i put the bike in gear the idling drops and the bikes wants to pull forward as if the clutch isnt engaging, but when i rev the clutch seems fine,...


the cluck need to be looked at as its draging its not fully disengaged witch is what makes the bike pull forwards when you put it in gear have a look at the free play in the cluch cable and if there is a lot take some out this will help to disengage the cluch a bit more but dont take all the free play out you need a little left in say 1/4 of an inch is plenty at the handelbars

Jan 14, 2010 | 2005 kawasaki KDX 200

2 Answers

Motor cuts out when gear engaged


Make sure you have your stand up before you put it in gear. Some bikes have a stand switch that doesnt allow the bike to be in gear while the stand is down. This switch may have been damaged when the bike fell and now be malfunctioning.

Sep 26, 2009 | Triumph Speed triple Motorcycles

1 Answer

Bike will start but quits as soonas I put it in gear


Starts and quits? No assuning - Gas? Spark?, Air?Choke Open? Will it eun with partial choke? Fuel filter restriction causes slow loss of power or sensation of running out of fuel. Electrical is go or no go, and quits suddenly like the key was turned off.. So I don't think its electrical. No assuming. double ck all and bypas fuel filter for testing.. Good luck. Double ck fuel valve.

Jul 01, 2009 | 2006 Daelim Daystar

2 Answers

My 125cc single cylinder (pulse adrenaline) cuts out at junctions


Since the bike is new, chances are strong that fuel IS the problem.
Also chances are that the carb is perfectly fine. Since the bike is new I'll bet yoy have washed it several times already. The dealer may have washed it also. Fuel is the problem because bikes do not run well on water.

Drain the carb. Remove the water trap bowl on the bottom of the petcock, (gas valve). Look at the gas in the bowl. Any water in the bottom of the bowl? Drain a cup of gas from the petcock. any water in the cup? I am very hopefull this will fix the problem. With a new bike and a clean carb and fuel system not much else should be wrong.

Mar 21, 2009 | 1990 Aprilia AF1 125 Futura

Not finding what you are looking for?
1996 Suzuki GSF 600 S Bandit Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...