Question about 2007 Suzuki GSX-R 1000

1 Answer

Red light on odometer comes on.... And f1 light also

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 333 Answers

That is the Suzuki equivalent to a "Check engine light"

Turn your key on and verify the FI light is on and that your red kill switch is set to 'Run'

Remove your seat and behind the battery area you should find a white 6 pin connector (likely with a black rubber boot on it) Using a paperclip connect the white/red striped wire to the black/white striped wire.

Your display should Now read whatever codes are active.
If it reads C00- then there are no active codes. Note that when you turn the key off, the memory is erased so if you have an intermittent fault you should not turn the key off until you pull the codes.

Codes are as follows:

C11 - CAMSHAFT POSITION SENSOR
C12 - CRANKSHAFT POSITION SENSOR
C13 - INTAKE AIR PRESSURE SENSOR
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C36 - SECONDARY INJECTOR SIGNAL #1
C37 - SECONDARY INJECTOR SIGNAL #2
C38 - SECONDARY INJECTOR SIGNAL #3
C39 - SECONDARY INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR
C49 - PAIR CONTROL SOLENOID VALVE
C60 COOLING FAN CONTROL SYSTEM



Posted on Sep 09, 2009

  • Norm N. Sep 17, 2012

    C28 is correct code problem. I'm following shop manual procedures and find STValve closes instead of open upon initial key on. Trying to avoid replacing entire throttle body for $500+.. Bike is Suzuki Bergman AN400K8 (2008)

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can someone please advise on an intermittent electrical problem on a Honda motorcycle dashboard.


Maybe a voltage issue you may want to have that analyzed Buy electronics person

Mar 16, 2016 | Honda Cars & Trucks

1 Answer

RED F1 LIGHT ON


on what bike mate, you need to be more descriptive, READ WORKSHOP MANUAL ON TESTING F1 LIGHT, THERE is a way to check the fault codes, but I recon it will come up 00

Apr 20, 2015 | Suzuki Boulevard C90T Motorcycles

1 Answer

My Kawasaki zx6r 2009 keeps displaying f1 and with a flashing red light. The bike runs fine. Sometimes shuts off while warming up. how do I fix it?


it actually means fault indicator and doesn't deal solely with the fuel injection.

put the key in the ignition and turn it on, but don't start the bike. use the mode button to go to the odometer display, then hold the mode button down for 2 seconds. the code should be displayed.

come back when you have the code

Apr 18, 2015 | kawasaki Motorcycles

1 Answer

Red light is on the odometer. It says check


A red light on the odometer in Camry's indicates a maitenance rquired condition such as air filter, oil change, or other detected change in performance picked up by the Camry's on board diagnostics compute r(OBD). The light can be reset and the instructions are in your owners manual as well as online. However if it has come on and you HAVENT done regular maintenance its time!

Jun 07, 2010 | 1997 Toyota Camry

1 Answer

Red warning light is on and f1 flashes were the temp shows 04gsxr


blinking red light means critical error check your oil if you have oil in the motor check the sensor on the oil pan! good luck! had the same problem wire was bear making contact at bottom near oil pan good luck!

Aug 29, 2009 | 2004 Suzuki GSX-R 600

1 Answer

Small red light next to odometer readout looks like a letter B


the B is for your trip meter not your odometer. the sx4 has 2 trip meters a and b that share the display with the odometer., yours is on trop meter b. press in the little black button next to the display to cycle through odometer, trip a, or trip b.

Aug 07, 2009 | 2008 Suzuki SX4

1 Answer

What does the F1 red light mean on a 2006 kawasaki VX636R motorcycle?


It's not F1 the light is FI F as in Fuel and I as in Injection.
This light should come on for a moment when the key is turned on and then go off.
Regards
Lon from Woodstock

Mar 10, 2009 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
2007 Suzuki GSX-R 1000 Logo

1,549 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...