Question about 1998 Yamaha FZS 600 Fazer

1 Answer

Replaced battery on 600cc fazer w reg,but wont start,i have got light and horn etc,i think its the alarm that is still on,any clues please its the 2nd battery i have put on it,it needs an optimiser putting on it,but have to get it going 1st,like i say i think that the alarm is still on so that is stopping the bike starting,

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You could have a problem with the started motor. Take out battery and remove spark plug, re-place battery in and try starting a few times without any throttle. Place spark plug in. full throttle and start. If tis does not work you may have a oily end of the spark plug in which case you should CAREFULLY remove it again and dry it off with a towel. try heating up the end of it gently with a lighter carful not to get it too hot or to burn the actual spark plug. you only want to burn off the oil. Reput it in and try starting it again.

Posted on Sep 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My car battery got dead so I bought new battery and tried to replace the old one. As soon as I reconnected the terminals of the new battery the car started making panic horn noise. Its horn alarm goes on...

On some models you can disable the alarm after you connect the battery by locking and unlocking the driver door with the key.
I would disconnect the horn or pull the relay until you can get the alarm turned off.

Sep 25, 2013 | 1999 Toyota Corolla

1 Answer

Hi there sp1 vtr 1000 (rc50) the bike drains the battery , now we put a new battery in it and replaced the stator/ reg/rector firer , if anyone has a clue please let me know :-)

Something is shorting the battery to ground. Try disconnecting all of the lights to see if one of their wires is shorted to ground. Then the horn...etc

Jan 22, 2013 | Motorcycles

1 Answer

94 camry alarm would'nt stop i pulled a black wir next to the horn now car wont start

the wire from the horn is part of an imobiliser so it wont start replace wire it sounds like imobiliser battery or alarm pad if wont turn off

Oct 13, 2012 | Toyota Camry Cars & Trucks

1 Answer

2001 GMC SIERRA 2500 HD alarm horn stopped working, reg horn dose'nt work either. Alarm lights still go off when activated through key fob. Checked all fuses and wiring, driving lights not working...

You need an ohm meter and check to see if ther is power at the horns and lights. There is no programming that turns off the horn on the steering column. But I have one of these trucks and had the same problem with the lights and horns but it didn't happen at the same time. My lightbulbs burnt out and the actual horns under the bumper did to. Hope this helps.

Jun 29, 2011 | GMC Sierra 2500HD Cars & Trucks

1 Answer

Peugeot 306 cabriolet R reg. no sound from alarm, but lights flash when turning it on with remote key. horn also not working.

attach a wire to the poss side of the battery and touch the horn terminal,if it sounds then you have a fuse problem,if not replace the horn....

Sep 21, 2010 | Peugeot Liberte Cars & Trucks

1 Answer

Hi. My 2002 Fazer is now on it's 3rd new battery. It seems to be drawing current when ignition is off (as I've measured it with a DVM) but I don't have any alarm or other device drawing power, only the...

What works when ign is off.Horn?Brake light?Those will draw power.Starters can drain battery to ground.Disconnect power wire to starter and then measure your dvm.Charger circuit goes thru alt.Disconnect relays 1 at a time checking dvm each time.

Mar 21, 2010 | 2002 Yamaha FZS 600 Fazer

1 Answer

We are installing a battery in our 2000 xterra the horn starts to honk. How do we install without the horn honking

This looks like you have a alarm problem,take the keys out and replace battery,if it starts honking press alarm off.If this don't work you have to find a Nissan workshop to calibrate the alarm and computer.It might be so bad that the car wont start at all after a battery change and that,s because the car was powerless for a short while and the computer thinks its been stolen and hotwired.God luck

Dec 12, 2009 | 2004 Nissan XTerra

1 Answer

How much oil should a v reg (2000) 600cc fazer take? 2.5l?

hi mate it should be something like that my gsxr 1000 take 3.0l also you can see by looking at the sight glass when you fill it up should come up to 1/2-3/4 full on sight glass this is located on side casing of engine

Aug 25, 2009 | 2000 Yamaha FZS 600 Fazer

1 Answer

My car will not start, jumper cables did not work, help me! :)

they don't always charge right up......sounds like you need a new battery....

Jun 22, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Bike does not start

Hi, I would start by checking to be sure the battery has a good enough charge, if not then locate the starter relay and try jumping the two terminals on it and seeing if the bike will start that way if so then you will need to replace the starter relay. good luck

Mar 08, 2009 | 2003 Yamaha FZS 600 Fazer

Not finding what you are looking for?
1998 Yamaha FZS 600 Fazer Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

281 Answers


Level 3 Expert

919 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides