Question about 2003 Suzuki VL 125 Intruder LC

1 Answer

Suziki intruder 1400 starts and runs in neautral but when i put it in gear and accelerate within seconds it blows the ignition 10amp fuse

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

You have a short somewhere in the ignition system. check for wires touching metal, or chafed and touching each other. Get a manual, and follow the wiring diagram.

Posted on Sep 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 Suzuki intruder 1400, was running great all day, when I turn it off and turn back on nothing happen no lights nothing, battery is good and tight. I check fuses all good.


Load test the battery. (most bike shops will do it for free) Check charging system. (should be 13.5vdc running at 3000rpm)
Also, sounds like you may have a bad ignition switch?

Aug 24, 2013 | 1998 Suzuki VS 1400 Intruder

1 Answer

Lights keep blowing the fuse


You can pull the light apart and check the amperage they require since they are not the factory headlights they most likely have a higher amp requirement and find out what that is and then install the proper required fuse for them. Also be sure to check and see if the wires are properly hooked up and wrapped properly and are not grounding out on any metal or other wires. This should solve your problems. Might also want to see if the headlight relay is also the proper one to cover the amps they require as well. Hope this works for u and good luck

Nov 30, 2012 | 1991 Suzuki VS 1400 Intruder

1 Answer

1996 Suzuki Intruder 1400 hard to start and runs rough in cold weather. Actually does not like the cold weather (florida cold weather). Replaced battery still having problems. When we finally get it...


Check the ignition system and set up the carb/s.
It sounds like the fuel mixture is too weak which could be a blocked tickover jet and/or the ignition system has a problem. If it is using a set of points, change the capacitor and check the points gap. If it is electronic ignition, check the ECU.
Hope that helps.

Dec 09, 2010 | 1996 Suzuki VS 1400 Intruder

1 Answer

My 1994 suzuki intruder starts but as soon as you


loose or broken ground wire ,could be broke under insulation, vibration of motor makes it lose contact. probably on gear indicator switch.

Jul 28, 2010 | 1995 Suzuki VS 1400 Intruder

1 Answer

My 2005 suburban AC is blowing hot air; one minute it was blowing out cool air and then it started blowing as if the heat was on....


If you touched any of the A/C controls within 45 seconds of starting your Suburban (after the battery change), you messed up the 'calibration mode' of the HVAC.

Pull the HVAC fuse (10amp) under the hood, and pull the two adjacent fuses (30 and 10amp) under the dash listed as 'climate control' in the manual.

Push the fuses back in, restart your car, but DONT TOUCH ANY of the A/C controls for 90 seconds.

I bet the A/C starts working again normally.

May 06, 2010 | 2003 Chevrolet Suburban 1500

1 Answer

Slight sliping in third gear when accelerating hard. Does clutch need replacing


If it is the original clutch I would say probably to check for sure go about 35mph put the bike in top gear 5th i believe on your bike give it full gas if the bike revs fast clutch needs repacement

Jan 30, 2010 | 1996 Suzuki VS 1400 Intruder

1 Answer

Im doing a oil change on a suziki intruder 1400 how many qts do i use a whats a good weight


many people will tell you what way to go, but ultimately it depends on your geographic location, and how hard you are on the bike. like what altitude, average temps..etc.
I would ask the local dealer about different choices, and then use your best judgement.

Sep 22, 2009 | 1996 Suzuki VS 1400 Intruder

Not finding what you are looking for?
2003 Suzuki VL 125 Intruder LC Logo

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...