Bosch Power box radio PB10 radio wont work

have you got it on am or fm--- am is non existent in some countries /areas and in other places there are fm 1, 2,3 so have you tuned it in properly

Bosch PB10 Operating safety Instructions Manual

http://www.toolpartspro.com/image/PB10-CD/PB10-CD-bosch-PB.pdf

Bosch PB10 CD 2610920592 Advanced Jobsite Radio Parts

there is no optical laser as a part for this.

If you remove the front face (radio side) you will see a black box. remove the screws and cover and inside upper left corner a little pcb, check the fuse.

Go and Look at eReplacementParts.com and the parts diagrams

did you check the fuse on the side of the box

replace the g.f.c.i.

Disconnected the GFCI outlets, and everything works just fine. Ridiculous that Bosch manufactures GFCI outlets that does not last for 2 years. The cheepest American made GFCI outlets last practically for ever. Beeing "Bosch", the replacement outlets cost $38 plus shipping.
It is ridiculous.

Mines similar, outlets work but radio will only work on battery. Radio will not work on mains only. Charger works at same time so ok. SORTED IT TONIGHT. Inside the charger inside the box there is a fuse (240v 2A) I think, tiny radio fuse. Changed that tonight and radio now works on mains only or battery. Very awkwark job but better than watching a load of cr** on tv. Hope this helps someone.

try a different power cord and plug it into a extension cord separate from the outlet you put your welder in. otherwise contact bosch thru website

Check the power source and be sure to press the power button and that should take care of it.