Question about Tomos Motorcycles
3 possible causes to investigate
1) The front brakes are binding. That is, not fully releasing after the front brake is applied.
2) The wheel bearings require adjusting.
3) The wheel bearings require lubricating
Posted on Jul 05, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: moped wont start
is there a spark a decent one if not try changing plugs if still no spark it could only be the cdi,coil and magneto get back to me buddy
Posted on Sep 13, 2009
Testimonial: "Awesome...just comepletely awesome thanks for all your help and look forward to more in the future "
does it get any power at all. check the main fuse located off the positive batery terminal. check all other fuses also.
Posted on Jan 08, 2010
SOURCE: Avid Juicy 7 disc brakes
It sounds like you have a piston that is not fully returned and is sticking.
Get a big flat bladed screw driver, take the wheel out and very carefully insert the screw driver into where the disc would sit and use the screw driver to try and push each brake pad back in without damaging your brake pads.
If this works go to a local bike shop and ask them for a avid brake insert for transporting your bike so this does not happen in future! :)
Posted on Apr 14, 2010
SOURCE: We have an older Tomos
most likely your idle is to high,,,,, and it is engaging the clutch,,,,lower your idle,,,,,slowly,,,,step by step,,,,till the rear wheel stops spinning,,, remember,,,,, with no one on the bike,,there is very little resistance,,,,, so the wheel will spin easily,,,,,adjust your low side r.p.m.,, and that should solve your problem,,,,,if it dosen't,,, your clutch is probably siezed up,,,, and will have to be replaced. where your throttle cable goes into the top of the carb. ,,, this is where you set your idle,,,,, the set screw is only for adjusting your richness,,,,,or lean fuel mixture,,,,, not your idle,,,
Posted on Aug 19, 2010
SOURCE: 2004 tomos revival moped a35
One little trick to find out if your running lean or rich.
When you get the sputter back off just a little on the throttle and hold it there.
If it Speeds up or settle down you are LEAN.
If it Sputters and then Speeds up or Settles down your running RICH.
Posted on Jul 20, 2011
Tips for a great answer:
Dec 08, 2016 | Tomos Motorcycles
Apr 21, 2016 | Tomos Motorcycles
Feb 09, 2016 | Motorcycles
Dec 26, 2017 | 2006 Tomos Revival TS
Oct 11, 2012 | Motorcycles
Apr 06, 2012 | 2006 Tomos Racing
Sep 04, 2017 | Tomos VRSCX Motorcycles
Jan 07, 2010 | 2005 Tomos Sm 125 F Replica cup
43 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: