Question about 1992 Yamaha XJ 600 Diversion S

1 Answer

Left hand fork oil seaql is leaking a bit is they a way i can fix the problem with out buying a new set.they have only bin done 2months ago by the previous owner.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Should be able to buy the seals individually. If they are leaking again, the previous owner either didn't install them correctly, or you have a bad fork leg.

Posted on Aug 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oily fluid leaking from front suspension forks. Both sides leaking how do i repair this.


Replace the Fork oil seals. It will require you to support the bike from the headstock and remove the forks. You will also need to know the correct amount of fork oil to put in each leg. Buy the manual for your bike (whatever it is) it will cost about 20GBP. a new set of forks will cost considerably more.

Aug 12, 2013 | Motorcycles

1 Answer

Had seals done by race tech not long ago leaking again after 3 months.Both tubes.left preloader has failed again also


It is best to replace the bushings when replacing seals to avoid this very thing from reoccurring. It would seem that, although the bushings look ok, they allow more slider movement than the new seals can tolerate...I recommend 15wt fork oil as well. It will keep the nose from diving so bad under hard braking...i hope this helps.

Jul 04, 2011 | Triumph Rocket III Motorcycles

1 Answer

The left front fork of my 1200 Sportster is leaking oil. How can I fix this?


That depends on where it's leaking. If it's leaking down at the axle, You can lift the bike off the ground, remove the front wheel. There's a bolt in the very bottom of the tube. Take the bolt out and slide the "slider" off the upper tube. While you have it off, replace the seal at the top of the "slider". This will fix any leak at the top of the slider. Clean the lower slider with clean mineral spirits and allow it to dry. Then, put a little bit of oil on the seal and a dab of clear RTV in the area where the copper washer goes and slide the slider back up on the tube. Put the bolt in and tighten it up. Replace the front wheel. Now, add the appropiate amount of fork oil for a "dry" refill. If you call the dealer, they should tell you how much oil goes in there. My manuals are not up to date for your model. Mine only shows for 1994 and Harley may have changed the fork tubes since then. Remember the higher viscosity of the oil, the stiffer the front suspension. The dealer will also tell you what oil came in the front forks from the factory.

Good Luck
Steve

Aug 19, 2010 | 2006 Harley Davidson XL 1200 L Sporster...

1 Answer

Honda deauville fork oil leaking out left side only done 3000 miles


Seals do have a habit of blowing ,but first you must check the stansions (chrome part of the fork) for rust ,best to replace with new,or get re-chromed British chrome is the most hard wearing,allso put a straight edge against the stansion in four locations to check for straightness 90^ appart.if any gap between straight edge and fork then replace or get engineer to straighten .

Mar 04, 2010 | 2001 Honda Deauville NTV 650

2 Answers

2001 yzf426 front fork leak


Each fork has an outer dust seal, and an inner seal inside of that. Dirt gets between the seal lip and the fork slider and causes the oil to escape. The fix is to have them (Both sides) replaced. You need a fork seal driver tool (Size specific for the size of the fork) and something to measure out the oil amount. It's not an easy job, if you have never done it. Also... if the oil has never been changed, it's due.

Aug 19, 2009 | 2001 Yamaha YZ 426 F

1 Answer

98 yzf 600R..Right fork leaking. Problem and fix?


it sounds like your fork seal has failed,it wont affect your brakes but will make your front suspension feel a wee bit "soggy"and will affect your handling,i would suggest getting the seal replaced as evetually the oil from the faulty seal will contaminate your brake pads that will affect your braking performance,replacing the seal,sooner rather than later ,would be a wise move..hope this helps...cheers

Jul 29, 2009 | 2004 Yamaha YZF 600 R thunder cat

2 Answers

How can I tell if my Fork tubes take fork tube oil or are Air ride....I don't seem to see the normal drain plugs for the fork tubes.


Most forks take Automatic Transmission oil ("ATF").
Most new motorcycles don't have drain holes for it is almost impossible to remove all of the oil through such an opening.
If the forks aren't leaking and are working, don't disturb them. If they are leaking you will need to remove and service them. This should be only done by a shop or someone who knows how.

Jun 16, 2009 | 1998 kawasaki VN 1500 Vulcan Classic...

2 Answers

2004 honda shadow 600 VLX leaking fork seal bike has 600 miles on it should I replace left and right if only right is leaking.


check first to see if the leaking fork has any rust pitting on the chrome,if it has and its a very small blemish then fettle it off first,and just replace the leaking seal,as the saying goes..if it aint broke dont fix it,if the seals had been in the forks for years and the bike not used then consider replacing both..

Jun 05, 2009 | 1986 Honda VT 1100 C

2 Answers

How to fill the front suspension on a ktm exc 2001


If you get the sevice manual or contact a dealer to get the correct oil amount for your bike, they need to know the model and year, you have to have the forks off the bike. take the fork caps off, take the springs out compress the upper fork tube all the way and add the specified oil. if they also give you the measured amount from the top that's the best way to get both fork oil levels exact. there is a special tool that you set the oil level in millimeters and it sucks out the oil to the right level, but before you do that step after adding the oil always pull and push on the cartage rod several times to remove air from the cartage tube. you will hear the air coming out and you will feel the changes in the cartage rod as the cartage tube fills up with oil and the air is removed.
something i'm confussed on though is if you replaced a seal you would have had to brake down the fork to replace it. you would have poored the oil into a container, cleaned all the internal parts,and used a fork seal driver to install the new seal. part of your question asks where do i put the oil in? thats in the open end of the fork after you have taken off the fork cap. It sounds to me like you only replaced the dust seal on one fork. that is not going to fix your leaking fork. you need to replace the oil seal thats pressed inside of the top fork tube.

Dec 01, 2008 | 2008 KTM 200 EXC

Not finding what you are looking for?
1992 Yamaha XJ 600 Diversion S Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...