2016 Hyosung GT 650 FI light flashing

SOURCE: Dishwasher fault

F1 Water heating fault, selected temperature not reached within 60 minutes · Incoming water temperature too cool
· Heating element burned out
· Thermostat defective

SOURCE: kenmore elite f1 code any one know what it means

F01 - There may be an internal problem with the control, attempt a Hard Reset.

Hard Reset - In some cases the control can be non-functioning or may not accept activation from the control panel. To clear and restart the control follow the these steps:

* Unplug or turn the circuit breaker off for 30 seconds.
* Reconnect the unit to the power source by turning the breaker back on or plugging the unit back into the wall outlet.
* Press the Pause/Cancel/Stop button twice to clear the "PF" in the display.
* Start a short cycle to check the operation of the machine by selecting a cycle and pressing and holding the start button until the machine starts.

The F01 generally indicates a failed electronic machine control board.
This error code can sometimes be caused by a glitch or power surge through the electrical lines.
You may be able to clear this code by unplugging the washer for 5 minutes.
If the code returns after plugging the washer back in, then the electronic machine control board will need to be replaced.

The procedure for accessing and replacing this control board is shown in this image...

http://media.fotki.com/1_p,wkwdftgtbkdgfrwxgtqsskgwtqkq,vi/ksrttqdqrxkssrqtgsd/1/1303472/5961857/image12917img-or.jpg

Be sure to unplug the washer before accessing internal components.
When you access the control board, I recommend transferring the wires from the old control board to the new replacement control board one connection at a time.
Once you have all of the wires transferred, remove the old control board and mount the new control board in the washer.
Reassemble and test the washer.

The "F01" error code indicates a communication error between the Central Control Unit (CCU) and the EEPROM onboard the CCU.
The "F01" can also be displayed if the onboard "Pump Driver" fails to activate.
Generally in order to correct this failure will require replacing the CCU.
There is no way to test and verify if the control board has failed.
The technical data sheet basically states to replace the CCU.

http://media.fotki.com/1_p,wkwdffkrdwtbgwsxgtqsskgwtqkq,vi/ksskgsfwrxksrttqdqr/1/1303472/5961857/image12923img-or.gif


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question$$$$

SOURCE: where can i get a 2009 hyosung gt 650 r owners

I have a problem wen i ride fore 10 km the bike cuts out and then i must leave it fore 5 mints then it will start and ikan drive fore 3 to 5 km then i must wait fore 3 mints agen

SOURCE: i have a hyosung gt

check the clutch cable isnt sticking if this is ok then im afraid it requires a new clutch

Ginko

• 19396 Answers
• Posted on Sep 09, 2011

SOURCE: ciao o una hyosung comet 650....mi

Ciao.

Probabilmente la guarnizione della testata e' andata. Prima di cambiarla controlla il mesh filter ed il sistema di carburante in generale. Qui il manuale di officina: SERVICE MANUAL - Hyosung.

Ciao