Having trouble with my meta alarm,fobs won't work so was using red code card to start bike with led but now my led has stopped working so cannot start bike at all now any ideas what's wrong thanks

Ginko

• 19396 Answers
• Posted on Sep 13, 2008

SOURCE: porsche key fob

If the key had gone faulty, the key code must be re programmed on the vehicle computer. This can be done only using a PIWIS tool, available at the dealer or at a qualified Porche garage.
Try also the following reset:
turn ignition on,
turn off.
remove the transponder from the column
push any button on the fob within 6 seconds.
This procedure will reset the key synchronizing again with the vehicle computer.

Marvin

• 85242 Answers
• Posted on Oct 16, 2008

SOURCE: key fob will not undo

If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.

If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:

1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.

5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.

6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.

7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.

SOURCE: Key fob on my audi a3 1998 has stopped working

You need to get the key re-programmed by Audi. Same thing happened with my A4.

SOURCE: 2004 xtype jaguar key fob suddenly stopped working

Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.

SOURCE: key fob lights up but doesn't work even with a new battery

I'm more familiar with Range Rovers and Saab's when it comes to key fobs but if you changed the battery you have to re-program the key fob. If you do not have an owner's manual that can take you through the steps you might want to try: push and hold the lock button on the key fob, put it in the driver's side door and turn to lock. With the button still depressed turn back to open, remove the key and release the button. If this doesn't work check any and all fuses associated with your system and last but not least you could take it to a dealer. Good luck!

Testimonial: "thanks ill try what you've suggested"