Stalls out at full throttle

Hi,

Please make sure that you're running the generator outside and that you've placed it in a position that's recommended by the manufacturer. I'm thinking that there is a safety protection (shutdown) being triggered by your generator because something is not setup properly.

Please call Generac for clarification on the issue: (678) 885-9751. Thank you.

if your saying that engine idles ok but anything over idle stall out your problem is a clogged carburator , try running some carb cleaner thru it , but most the time i end up dissasembling it and cleaning it !! if your saying that at full throttle the engine stalls out , your pushing the throttle up to far and it's going to cold start posisition (choke)

If it stalled. Add more gas. Mine does same thing.

carburetor needs to be cleaned. probably wouldn't hurt to clean the fuel filter as well.

proberly running rich

Sounds like its not "un-choking" it self, that its running like its still choked like you wold at initial start up.

Disassemble it and see if u can pysically see the activation and deactivation of the choke when u apply them.

While u are at it, also make sure:

Gas is fresh?

MIx is right?

Plug is good?

Chain brake mechanism is released.?

Good luck.

You need to play with the timing adjustment, either on the spark plug, or the gap between the contact and the magneto.
That'll do it ;)
Don't forget to rate, thanks

You need to clean the carburetor. Disassemble the carb. and spray with carb. cleaner. If you need tip on how best to do this, just let me know. If after you have reassembled and tried to start, and it still does the same thing, you will need to buy a carb. kit and replace all appropriate parts.

Jim

You need to rebuild the carburetor. You will need to go to an outdoor power & equipment store of some kind to get a carburetor kit for your specific trimmer. It will come with various gaskets, (some of which you won't use), a needle valve, and a small screen that goes in the carb. Replace all old parts with new. New primer bulb is sold seperately. When you have the carb. apart, you will also need to clean the small ports with a Den Tek Brush (used for cleaning teeth). Use carb. cleaner when cleaning.

Jim

Most likely carburetor needs adjustment.