Question about 1999 Honda V-Twin Magna

2 Answers

How do you check oil level? what is the correct way to do it?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 53 Answers

Un do the oil cap ond there is a stick on it to measure it

Posted on Jul 30, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Start and run the bike for a few mins. Shut the bike off. Make sure the bike is level. unscrew the cap and there is a matal rod on the end of the cap. wipe the stick clean. reinsert the rod into the oil, btu do not screw the cap in. the oil level should fall between the two marks engraved on the stick.

Be sure to check out the Magna forms for more help / Info.

http://forums.delphiforums.com/MagnaRider
http://v4hondabbs.com/
http://www.magnaownersoftexas.com/forums/

Posted on Sep 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 Chevrolet Malibu oil light on & valves clattering


Check the oil level on the dip stick and make it correct. This engine should have a low oil shut down feature. Possible oil pump failure. With oil at correct level, restart engine. If the oil light does not go out with engine running, shut down immediately. Severe Internal rotating component bearing damage has already occurred. look for loose oil filter or hole in oil pan.

Mar 03, 2017 | 2002 Chevrolet Malibu

1 Answer

01 vw beetle ck engine oil lite beepflash said to much oil stripped oil plug new oil pan7days lite on engine warms up if i stop goes offthen back on again


If your oil is at the correct level, then the oil level sensor is not working correctly. If your oil level is low, then you need to fill it to the correct level

Feb 17, 2017 | Volkswagen Beetle Cars & Trucks

1 Answer

Onan generator cranks then wines no start i have a onan generator in my motorhome it stop running now when i try to start in it turns over but does not run what should i9 cheack


check oil level in the sump
if the oil level is correct check for a problem oil level sensor circuit
it is there to stop the engine when the oil level reaches critical level

Dec 12, 2016 | Electrical Supplies

1 Answer

How to change gearbox and engine oil


There is a sump plug located at the bottom of the engine. It is very tight. Make sure you have the correct size socket to remove the plug. Use a suitable oil pan under the bike before removing the plug. Once the plug is removed and the oil is drained, stand the bike upright to get the last of the oil out. Get the correct oil, about 1 litre, replace the plug and fill the bike to the correct level using a funnel. Stand the bike upright to check oil level. Do not screw oil dip stick in to test the level.

Nov 02, 2013 | 2008 Yamaha YZF-R125

1 Answer

Check oil level stick


Always check oil levels whit a cold engine! This gives the only correct oil level. And make sure the engine is level, else you get a false reading.

Sep 27, 2013 | 2004 Triumph Rocket III

1 Answer

I have a1996 toyota camry 4cyl automatic transmission i bouth not to long ago i check the fluided levels when i got to the trans the oil was black so i change the gasket and filter and new trans oil and...


Make sure you are useing the correct oil There are abrasove plates inside the transmission that are supose to grip agenst each other to drive the shaft . Black is no good is should look red **** new if everything is working correctly but some transmisstions need a vary sI hope its not shotpicfic oil check the oweners manual or the dealer for the correct oil. Hope its not shot good luck

Mar 08, 2012 | 1996 Toyota Camry

1 Answer

2005 grand Prix oil pressure light an dinging comes on


1. Check your oil level. If oil level is not ok, correct oil level and find out why oil level was low and correct the problem. (Leaks, bad PCV, Burning oil due to severe engine wear, nobody has bothered to check it for the last 3000 miles, WAY overdue for an oil change, etc.) If oil level is ok, proceed to next step.

2. Remove the oil pressure sensor and install a manual oil pressure gauge. Run engine to verify low oil pressure. If gauge shows that the oil pressure is low, overhaul or replace engine. If oil pressure is ok, replace oil pressure sending unit and retest.

Mar 06, 2012 | 2005 Pontiac Grand Prix

2 Answers

Oil press. stop motor is written on the dash. I'm due for a oil change...is it dangerous to drive my car with this notice?


yes, you are in danger of ruining your motor.. check your oil by pulling out the dipstick, wiping the oil of the end of the dipstick and replace it fully down again into the dipstick tube. Pull it out again and check the level of the oil. If it is low, add oil before driving. If it does not show on the dipstick, add 1 quart at time and check the level each time before adding more, until it is to the correct level marked in the dipstick

Mar 25, 2011 | 2004 Volkswagen Passat

1 Answer

Oil is comong out of crank case breather,oil level in motor is correct


make sure u hav correct grade lubricant-the oil maybe to thick or double check level to make sure its not too high

Aug 30, 2010 | Honda CRF 450 R Motorcycles

1 Answer

Transmission fluid level check


The owner of the car should be able to check the oil fluid and coolant levels .get a clean peace of cloth.tools for removing trans axle /differential filing plugs. so that when the oil or fluid and coolant levels are checked they must be on desired levels.Locate the oil metering rod or dipstick and measure the lubricating oil level. Remove the transmission filler plug and check oil level. Remove differential oil filler plug and check oil level .Check fluid level .check coolant level.Observe all safety rules .Use the correct preventive maintenance procedures. If the owner can't do it then it is suggested that he should go to a car mechanic and the mechanic will do the job.

Oct 01, 2009 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Honda V-Twin Magna Logo

Related Topics:

683 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...