Speed Pro camshaft #C1024R

It is all here complete with pictures and diagrams. A Service Manual of your own is a great investment as stated by our Pro Tech Larry Ng.

https://www.google.com/search?q=2008+chrysler+300+touring+3.5+V6+head+camshaft+bolt+torque+specs

..

Cam companies usually have help lines to match a cam to your engine configuration . They have custom ground profiles that will work with your SBC .

Are you doing all this work without a shop manual? It should have the info you seek.

Try contacting Iskendarian for the spec sheet.

contact a cam shaft shop that does grinds or a speed shop that sells cam shafts and recite the numbers and they should be able to tell you what cam it is . If the cam has a makers name that will be a big help as well

Most factory small block chevy heads can only take a .500 lift cam unless creative machine work has been done. By looking at the cam shaft card and using a degree wheel this will determine the out come performance and as a general rule for valve train geometry at mid lift of cam shaft the rocker arm should be 90 degrees to the rocker stud. if not a longer or shorter push rod is required . the cam card also gives the free length height of the valves with a closed pressure reading this very important for cam life and helps prevent valve float at high rpm's with full open valve spring pressure.

For camshaft timing spec,click the link below :----Ford Mondeo ST220 camshaft Timing specifications? http://technoanswers.blogspot.in/2012/02/ford-mondeo-st220-camshaft-timing.html
-------This will help.
Also check this related help links:---

How test cam shaft? Testing Car Camshaft? http://repairhelpcenter.blogspot.in/2012/02/how-test-cam-shafttesting-car-camshaft.html
----------How to Inspect Camshaft? http://repairhelpcenter.blogspot.in/2012/02/how-to-inspect-camshaft.html
------------Crankshaft and camshafts timing marks? http://technoanswers.blogspot.in/2012/02/crankshaft-and-camshafts-timing-marks.html
----------Camshaft, Bearings & Lifters Replacing ? http://howtobyme.blogspot.com/2011/12/camshaft-bearings-lifters-replacing-on.html
---------Camshaft Position (CMP) Sensor replacing? http://schematicsdiagram.blogspot.com/2011/12/gmc-camshaft-position-cmp-sensor.html
------------How to replace Camshaft? Replacing Vehicles Cam Shaft Assembly? http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-camshaft-replacing.html
---------This will help too.Thanks.

1999 to 2002 - 2.0L DOHC

Camshaft bearing cap bolts intake and exhaust.

N.m (INCH LBS)
8 ( 71 )

CAMSHAFT POSITION SENSOR 2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl The Camshaft Position Sensor is located: Under hood, center, upper engine area, rear of intake manifold, mounted in distributor

If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants

If your going to do do that much work , I would invest in a Chilton's or Haynes manual