Question about 2003 Harley Davidson FLHRCI Road King Classic

2 Answers

2003 roadking shut off and wont start. motor turns over fine but no luck on getting it running. replaced crank sensor and charged battery. no luck. 39,000 on odometer. bike does have a power commander. asy suggestions? thanks.

Posted by on

  • Lotech73 Jul 31, 2009

    since this bike was left to me by my late father, i wasnt the one who installed it . is this a simple plug and play setup? im not too savvy with this fuel injection stuff.

  • Lotech73 Jul 31, 2009

    okay, tried that. no change. im thinking eng temp sensor or main circuit breaker? maybe fuel system components? man am i lost here!

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 148 Answers

Try removing the power commander to see if that is your problem.

Posted on Jul 29, 2009

  • Mike McDowell Jul 31, 2009

    Hi,


    Yes if you look under the right side access cover (just in front of the right saddle bag) you should see the power commander) just remove the plug that is going into the PC and plug directly into the ECM (Electronic Control Module) if the bike starts then you have a bad PC. Do not run the bike without the PC for long. Just long enough to verify that that is your problem. If it is then you'll need to replace the PC (My local dealer sells them but if yours doesn't then go to the PC website and the can tdell you who does locally).


    Good luck!

  • Mike McDowell Jul 31, 2009

    Ok...


    Here what I would do. Go to the dealer and buy the service manual for your bike (Mechanical/Electrical). The book will show you how to check the engine codes (I.e. it will tell you which sensor is bad). The Service Manual is about $50.00.



×

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 3 Answers

Try your fuel pump fuse.?
its located right next to your power commander , could also be the ecm fuse

Posted on Apr 16, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Jeep chorokee ran fine but alterantor died. I replaced that but now I am getting a code 54 and it wont turn over. Any ideas?


Are you saying the starter motor won't crank the engine? If so, I'd have to make sure battery has a full charge and battery connections all good. I'd also check the starter motor wiring circuits. Any testing at starter motor, make sure tranny is in park or neutral and parking brake is set.
Now, if it cranks good but won't start, have a helper crank it while you check for spark at the spark plugs, if spark everywhere, use a gage and check proper fuel pressure and fuel injector pulse.
Code 54 should be for the cam sensor in distributor. If I get a code for cam or crank sensor, I usually check them both. I check the wiring circuits.

Nov 13, 2017 | Jeep Cars & Trucks

1 Answer

96 plymouth voyager will not start after shutting when driving.


-Possible crank sensor is bad. or low fuel pressure, broken fuel pump.


Good luck


Mai Lor

Apr 11, 2014 | 1996 Plymouth Voyager

1 Answer

My 2003 galant runs but when i shut it off i need a jump i had a service engine light on and it said i needed a camshaft sensor replaced now nomore light but car still wont start without jumps


Needing a jump can mean several things.
The cables could be dirty or not tight again, the battery may be loosing power if the car sits, and so on.
Someone would need to check the battery with a meter when it won't crank and find out if the battery is fully charged, and if the starter is getting power.

Jan 12, 2013 | 2003 Mitsubishi Galant

1 Answer

2003 Harley xl 883 wont start, what haven't I thought of?


Hi Mystr_e119, you may have a faulty CKP sensor, for more information about your question please visit the websites below. Good luck and have nice day.
http://harleymanual7.blogspot.com/2011/05/how-to-test-harley-crank-position.html

Jun 17, 2012 | Harley Davidson XL 883 R Sportster...

1 Answer

2003 land rover freelander will not start


cheaper to have codes read than replacing parts that may not be required, but yes could be crank sensor

May 26, 2010 | 2003 Land Rover Freelander

1 Answer

I have a 2003 stratus and it wont start... Crank sensor???


In a HOT day,old battery and fuel pump will be the prime troublemaker.

You need to charge up the battery and check for 12.4-13.6V range.

How old is the battery?

Most are warrenty for 24,48 or 96 months.

====
Fuel pump motor portion will ran forever. But the plastic diaphragm will give out in a hot day.

Do a fuel injector pressure test. Below 40 pis is trouble.

Fuel filter should be change if the fuel pump is at fault.


ALL more gas until it's over 1/2 tank and re-test.

A weak fuel pump will take more effort to pull fuel from a near empty tank.

Good luck,

Jul 15, 2009 | 2003 Dodge Stratus

2 Answers

2003 pt cruiser sensors


check the battery and make sure it has a fully charge,also check to make sure the start motor pinion is not jammed in the flywheel, and check the coil pack to make sure have spark.also check the crank sensor

Feb 14, 2009 | 2003 Chrysler PT Cruiser

3 Answers

Starting problems with my 2003 Hyundai Santa Fe


I have an 03 Santa Fe as well and just had the exact thing happen to me. One day, it just wouldn't turn over at all and I had to have it towed to the dealer. They replaced the "crank shaft position sensor" and now the car is fine. I am not sure if this is your problem but it might be worthwhile asking someone to check it out.

Dec 29, 2008 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
2003 Harley Davidson FLHRCI Road King Classic Logo

739 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4753 Answers

Mike

Level 3 Expert

4348 Answers

yadayada
yadayada

Level 3 Expert

78289 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...