Question about Keeway Arn 150 Motorcycles

1 Answer

I have a 2007 keeway arn 150cc scooter i got alot of battery power and it will turn over but it will not start please help me with the problem.?????

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 99 Answers

First of all, was the bike running, then parked for a signifigant period of time? if so, the first thing your going to want to check is the fuel system. theres a fuel hose running from the fuel tank to the carburetor. remove the fuel line from the carb to check the condition of the fuel. fresh gas has almost a clear look. if it appears to be fine, then proceed by checking the carb to see if there is fuel in the reservoir. at the bottom of the carburetor, there should be a small screw. turn it out counterclockwise to see if gas comes out from one of the overflow fittings on the carb. if it begins to leak, then you most likely have enough fuel in the carb to start it. if it comes out of the hose looking dark, or smelling kind of funny, then youll need to clean the fuel system. to do that, you must drain all of the old fuel, flush the fuel tank a bit with fresh fuel, refill it with fresh fuel, and also clean out the carburetor. if youve never done this before, i would reccommend having a technician do it for you. lost parts or mis-adjusted carburetors can not only cause mechanical damage, but also be a potential safety hazzard due to performance problems. if the fuel looks and smells fresh, then your going to want to check for ignition next. remove the spark plug from the cylinder head, attatch the boot to the top of the plug, make sure the electrode end is touching a good grounding point on the engine, and press the start button. BE CAREFUL on this step. if the plug sint grounded well, it could lead to you getting an electrical shock from the ignition system. its a good idea to hold the spark plug or boot with insulated pliers during this step, just as a precaution. while the engine is turning over, watch the gap on the spark plug end to see if there is a noticable spark. it should be fairly easy to hear as well. if there is spark, then your ignition system is most likely in good condition, so move on to the next step. if there is no spark, try this process over with a new spark plug. if the new one still doesnt spark, there is a problem with one of the components in the electrical system, and that should be further diagnosed by a certified technician.
I hope this helps you out a little bit. these are the first things that I would check. If you know the fuel system is in good condition, and you can see that there is a good ignition source, then you have a mechanical problem that would require more information to attemp to diagnose. if you have any questions, feel free to contact me. Ill be happy to further clarify or explain anything that I mentioned here.

Posted on Jul 28, 2009

  • cancun20002 Mar 13, 2012

    I have the same problem and all that stuff mentioned above was done. even my mechanic at the dealer is stumped. any other suggestions

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 keeway hurricane and wont start


Hi, Brandon the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or damaged battery, 9 volts or lower.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. Gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable free downloads that you need please visit the websites below. Good luck and have a nice day.
50cc keeway hurricane problems
Help Scooter won start cleaned carb which hoses
Scooter Troubleshooting Scooter won start All about Scooters
http://www.49ccscoot.com/manuals/Keeway_50cc_2T_Service_Manual.pdf

Feb 21, 2016 | Keeway Motorcycles

1 Answer

Where is the battery on a 150cc taotao scooter


Hi, George sorry you can't find the first and best tool you ever bought for your TaoTao despair not for a mere $0 you can download another one. For more information about your issue and free downloads that you will need please visit the websites below. Good luck and have a nice day.
How to Assemble TaoTao Gas Powered Scooter Part 3 Battery Installation
Battery Installtion and Connection Tips Chinese Scooters Help
TaoTao 150cc Scooter Owners Manual
TAO TAO ATM150 Assembly Video


Feb 01, 2016 | Motorcycles

1 Answer

My keeway superlight 125cc I have fitted a 150cc


Hi, Anonymous first thing is you forgot to measure the aftermarket for more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
piston slap issue
http://www.antiquemotorcycle.org/bboard/showthread.php?19951-What-Causes-Piston-Slap-amp-or-galled-cylinders KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR PDF MANUAL DOWNLOAD 2006... $12
Keewayparts com Genuine Keeway Parts Shipped Worldwide
KEEWAY HURRICANE User Manual

Aug 05, 2013 | Keeway Matrix 150 Motorcycles

1 Answer

Keeway xray wont start


Hi, Bernado45 before testing any electrical component in the Starter Circuit it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test because your battery may have 12.5 volts or more but little or zero amps causing the battery to be faulty and must be replaced, especially "AGM" batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Security alarm needs a reset.
10. Starter relay, solenoid or starter circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Keeway hurricane won start 49ccScoot com Scooter Forums
Scooter Troubleshooting Scooter won start All about Scooters
KEEWAY 50cc Series Service Manual
Quality Replacement Parts For Keeway
KEEWAY QJ50T 21U Maintenance Manual

Apr 07, 2017 | Keeway Motorcycles

1 Answer

The Keeway Flash I have has not been started for a few months and when I tried to start it after charging the battery over night it still would not start. I have cleaned and re gapped the plug and even...


Hi.

Keeway scooters usually do not have kickstand switch. Check if there is one just in case. If there is kickstand switch bypass it.

Check fuel switch, fuel filter and hose.

Try starting with no fuel cap.

Check and replace spark plug.

Check carburetor oil and oil tube.

Check carburetor mixture and idle settings.

The carburetor needle may be clogged in some case the carb must be disassembled to clean part or regulate needle height. Unscrew the discharging fuel screw for the carburetor and check if there is fuel flow. If fuel flows test the ignition wiring , CDI and coils in the magneto.

I do not have the service manual for this scooter.

Here a service manual for a Keeway ARN 150, similar to Flash

Check the service manual tests and diagnostics are the same and wiring diagram is similar.

Regards.

Ginko

Oct 31, 2011 | 2008 Keeway Matrix 150

4 Answers

Theres a cell phone light on the dash of the scooter and i dont know what it is for on my keeway matrix 150cc


Usually when you drive a bike it's very noisy and you feel vibrations through your body, this will prevent you from hearing a call ring or call vibration, that light on the scooter shows you when you get phone calls (is activated by the waves of the call you get on your cell phone).

Mar 05, 2010 | 2008 Keeway Matrix 150

1 Answer

My Brand New Chinese 150cc scooter does not run unless you spray starter fluid in the carb and then it dies after 15 sec. Thank for your help. T.J.


buddy dont use starter fluid or your engine wont start with out it try spraying fuel on the inlet and see if it runs then get back to me if it trys to run

Oct 08, 2009 | 2008 Keeway Matrix 150

1 Answer

Can't get Keeway ARN to start


If you did not prep the bike for winter storage with Sta-Bil in your gas you might have some clogged carb problems You say this is a scooter but the description at top calls it a motorcycle. If it's a scoot then your engine and carb are underneath all that plastic your sittin' on.If it's a motorcycle your carb is right behind the engine between ur legs. It has a rubber gas line connected to it. Get some starter fluid from your local auto parts store and spray a short burst into the air cleaner and then hit the starter button. It should start but if it won't sit there and idle youv'e got a plugged card idle jet...time for a mechanic....next year prep the bike and disconnect the battery and you won't have to buy a new one....Good Luck !!

May 04, 2009 | 2008 Keeway Superlight 125 II

1 Answer

Keeway Arn 150 - not dependably keeping a charge


bad rectifier.  Whats the voltage across the battery with the motor revved?  It should be about 14.4 Volts DC if its not, replace the voltage rectifier and the voltage regulator. 

Mar 25, 2009 | 2008 Keeway Arn 150

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

975 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keeway Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Ron Stone

Level 2 Expert

197 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...