Question about 2005 Yamaha FZ6 Fazer

2 Answers

I have a 2004 r6 i started having trouble with it stalling out when i would come up two a stop and as long as i kept giving it gas it would be fine. recently cleaned air filter and replaced spark plugs so i know its not that. now when i start it it wants to stall out and doesnt idle right if i turn the bike off and restart sometimes the problem will go away. also when riding the bike seems real sluggish and i can see there is carbon building up on the tip of the exhaust pipe. if anyone has gone through this or knows what might be happening i would appreciate the help.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem with my fz6 fazer. It was the throttle bodies out of balance. It is a common thing I understand. Try that!!

Posted on Jul 31, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 188 Answers

Pull the new spark plugs and compare them to a condition guide which should tell you if fuel is too rich/lean. souns like running rich.

Posted on Jul 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 yamaha r6 runs rough and stalls after bike has warmed up


Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking check for spark leakage in the dark.
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP sensor.
9. Intake air leak.
10. Water, dirt, or rust in the fuel system, carburetor and/or filter.
11. Fuel tank vent system plugged or carburetor vent line closed off.
12. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
13. Carburetor controls misadjusted.
14. Damaged carburetor.
15. Incorrect valve timing.
16. Weak or broken valve springs.
17. Damaged intake or exhaust valve.
18. Check for engine trouble codes
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
07 r6 rough idle then stalls on cold start
http://www.pashnit.com/forum/showthread.php?12227-Need-Help-R6-stalling-on-me
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Feb 18, 2014 | Yamaha YZF-R6 Motorcycles

1 Answer

Why does my yzf r6 keep dieing i just changed the plugs but it acts like they are bad again


Can you give some more info? What did the plugs look like when you took them out? When did the problem start? What made you change the plugs? have you done anything else to the bike? any damages to it?

Mar 30, 2013 | Yamaha YZF-R6 Motorcycles

1 Answer

2003 Yamaha R6 Bike stalling


Hi, Elec2512 and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Accelerator pump damaged or not working.
11. Water or dirt in the fuel system, carburetor or filter.
12. Restricted, blocked or kinked fuel line.
13. Fuel tank empty.
14. The gas cap is not venting properly or fuel tank venting system blocked.
15. A failed fuel pump, pressure regulator and or fuel injectors.
16. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
17. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
http://www.r6-forum.com/forums/57-garage-mechanical-help/91441-bike-stalling-when-i-stop-wont-stay-idle.html
http://www.r6messagenet.com/forums/r6-maintenance-technical/14953-03-still-stalling-idle-input-please.html
2003 2004 Yamaha YZF R6 Service Manual R6 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

May 19, 2010 | 2003 Yamaha YZF-R6

1 Answer

No start concern - Mitsubishi Outlander 2004


Check the IAC valve...or sometimes known as an electronic choke. That valve is how your engine gets air when the throttle body plate is closed. If the valve is stuck due to malfunction or carbon build up then it will cause that problem, and give you a rough idle at best.

Dec 28, 2009 | 2004 Mitsubishi Outlander

2 Answers

Stalls after getting gas then starts fine. Also noticed it idles rough at other times. No trouble codes. Any thoughts?


When it stalls after getting gas, are you filling the tank up beyond the first stop? I was filling mine up after the pump shuts itself off in order to top it off as much as possible. I learned this can plug some type of purge vent or something like that. I stopped topping it off and haven't had a problem since. Mine would hesitate and then die at the first couple stop lights after getting gas. From what I've read, the cheap fix is not to fill it up past the stop point, but the permanent fix is to replace the gas tank since the vent physically part of the tank.

Apr 21, 2009 | 2004 Dodge Caravan

2 Answers

Low idle/stalling/power loss


I have the exact same problem. Let me know if you find out what it is. kherron@mcloudteleco.com

Mar 19, 2009 | 1995 Ford Mustang

1 Answer

04 Saturn stalling on take off and stops.


Pour the fuel injection cleaner to it....sounds like the injectors are dirty.....

Jan 30, 2009 | 2004 Saturn VUE

1 Answer

Truck will idle but stalls when i try to give it gas


I do not know what engines yu guys have but this does sound like fuel starvation. Replace the fuel filters and go from there

Good Luck

Jan 11, 2009 | 1989 Ford F 250

1 Answer

2000 grand cherokee v8 struggles to start and stalls when slowing


i think your exhaust might have a leak which is heating up your oil when this happens the engine suffocates and wants to die.

Dec 02, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2005 Yamaha FZ6 Fazer Logo

290 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...