Question about 1994 Yamaha FZR 600

2 Answers

Fuel commin out over flow for a couple days then it woudnt turn over fuel went in my oil

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Floats in carb are stuck. They will have to be removed and cleaned in solvent or equivelant

Posted on Jul 24, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 202 Answers

If it is carburetor the float is stucked or also their is a small valve that closes when the float reaches its level to prevent for fuel to reach the carburetor this valve is not closing properly. Need to adjust float or change valve. Also try giving a small tap or knock with the end of a screwdriver to the bottom of the carburetor if the float is in the up position the float will drop so no more fuel will be coming out over flow, so u don't have to take the carburetor down

Posted on Jul 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1981 oldsmobile delta 88 royale and it was running fine and starting right up the a couple days ago I went to start it and it wouldn't start it will turn over and act like it's going to but it...


Fuel pump is usually. In the gastank u will need to drop it also fuel filter. May be under the driver by the frame. I had a similar issue. It turned out my spark plugs were bad they had oil on them making it harder to start.

Jan 23, 2015 | Oldsmobile Cars & Trucks

1 Answer

My 98 jetta will just stop like if u turned the key off


Fuel injection cleaner and run couple gas treatments every now and again... my jetty is finicky like that too.. replace fuel filter every 30k miles

May 15, 2012 | 1998 Volkswagen Jetta

1 Answer

Th engine turns over and will not start. I have fuel but no spark from the spark plugs. I drove it the day before with no problems and when I went to leave my job it woudnt start.


Hello and welcome to FixYa!

As a first course of action, replace the distributor cap. If the cap is worn out it tends not to give current to the plugs. If problem still persist then the problem will be on the distributor coil pack itself. It's the main supply of current to the plugs. Located inside the engine where the distributor cap sits.

Hope this helps and thank you for using FixYa! Have a good one!

May 05, 2011 | 2006 Mitsubishi Galant

2 Answers

3 weeks ago I had my coleman 5000 generator in to be fixed. The man flushed the gas tank, replaced the carb, did a tune up,changed the spark plug, and did an oil change. When I went out to start it a few...


You got spark & compression
The air filter is not an issue
You got clean fuel
You got oil and the machine is not freezing
Sounds like the exhaust port is open and free

Fuel is the only suspect remaining

Pull off the fuel line and see if gas flows to carburetor.
Pull off gas filter and see if gas flows free
Try some gum out

Now here's something we discovered.
Our machine wouldn't run on full throttle.
We had to set it at half throttle, and it ran like a top for years.

Try messing with the throttle settings to find a setting that works.
Finally, if none of the above work, it must be the carburetor.

Oct 21, 2010 | Coleman Powermate Premium Plus 6250W...

1 Answer

Dodge commins Code Fuel Calibration Error. what is


Hi
The reasons for Fuel Calibration Error are many...
Faulty Fuel pump
Excess anti freeze in the fuel.
Faulty setting of fuel injection system. i.e. wrong mixture being sent to the engine block.
Faulty or damaged Turbo assembly.
You will have to do an diagnostic check to find the real culprit.

Regards
Berry

Feb 01, 2010 | 1999 Dodge Ram

1 Answer

2001 dodge truck wont start


dear friend:code p1601 stands for engine control module(ecm)transmission control unit(tcm)-serial peripheral comminication malfunction,code p1282 stands for fuel pump relay-open circuit,fuelpump relay faulty and p1687 stands for metering oil pump-high flow-circuit malfunction,(wiring metering oil pump switch metering oil pump and ecm

Sep 22, 2009 | Cars & Trucks

Not finding what you are looking for?
1994 Yamaha FZR 600 Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...