Question about 2005 Gilera Runner VX 125

1 Answer

Gilera noly starts when revved

I have a gilera 50 cc 52 reg, was working fine then suddenly wont start unless revved at the same time and i have to continuesly rev the bike to keep it on otherwise it cuts out after about 30 secs?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

Hi mate on the carb there will be a screw get a cross head screw driver and turn this screw in a 1/4 of turns this is the idle screw which should bring the revs up a tad remember its the screw that is sticking out good luck

Posted on Jul 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gilera 50 Front Runner will not turn over


Hi, Luke before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Gilera DNA electric start not working
Scooter Troubleshooting Scooter won start All about Scooters
https://scootergrisen.dk/scooterhjemmeside/download/gilera_runner_rstsp_servicemanual.pdf
Gilera RUNNER 50 2000 Parts
https://www.eumoppenomc.se/WebRoot/Ballou/Shops/moped/4E2E/640B/3A3C/9A86/C6E0/0A0C/05E9/B1B7/Manual_GILERA_Runner_SP_50.pdf

Jun 21, 2017 | 2008 Gilera Runner SP 50

1 Answer

Gilera runner 125st acceleration problem


First check it is a 125 cc engine. And not a 50 with a 125 body and stickers on it. If it is the 125 then check the timing (ignition) as this will be controlled by a box full of electronics and if only one component fails it could give the same symptoms as you describe.

May 17, 2013 | 2009 Gilera Runner ST 125

1 Answer

How do you check an alternator for a gillera 49 cc bike


Hi your spark problem wont have anything to do with the alternator?
This happened to a motor bike i owned and found that the rectifier regulator needed to be replaced that fixed the problem and the bike has worked fine since.
The rrectifier regulator is generally next to the battery and will have a big plug going into it.

Jun 13, 2012 | 2005 Gilera 50 RCR

1 Answer

Gilera runner 50sp 06 (New shape) keeps bogging out when acc


why is my gilera bogging out when i drvie it on the flat

Nov 24, 2009 | 2006 Gilera Runner VX 125

1 Answer

Gilera runner sp 50 2003 wont start


Sounds like your oil/ fuel mixing valve may need to be replaced. New gaskets for it at least. Hopefullly your engine gaskets are ok, that's the first thing I thought of until I saw it was a 2 stroke.

Oct 03, 2009 | 2005 Gilera Runner VX 125

1 Answer

I have a gilera dna 125 4st it takes lots of turns


the spark plug possibly get back to me if thats ok

Sep 16, 2009 | 2005 Gilera Runner VX 125

1 Answer

Carb tune up gilera runner 50


on the carb you will find 2 screw one will be quite far in than the over thats the one you adjust this is the mixture screw which controlles the air and petrol together unscrew it say 1/4 a turns at a time and see if it improves if it gets worse screw it the oposite way and see if that improves good luck buddy

Aug 10, 2009 | 2005 Gilera Runner VX 125

2 Answers

Gilera runner sp50 - engine turns over but does not start


you went through the electric. system, now check fuel supply filter, tank, valve carb bowl for dirt

Aug 08, 2009 | 2005 Gilera Runner VX 125

2 Answers

Gilera runner 50cc wont start


Don't do the gas down the spark plug thing. It's a bad idea. Do the following >
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

May 25, 2009 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
2005 Gilera Runner VX 125 Logo

Related Topics:

368 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gilera Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4525 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Fabrice Wolters

Level 2 Expert

265 Answers

Are you a Gilera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...