Question about 2008 kawasaki Ninja 250R

2 Answers

What kind of plug use to ninja 250 r - 2008 kawasaki Ninja 250R

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Go to your local kawasaki dealer for 2008 2009 ninja 250 the spark plug number and brand is brand=ngk part number=cr8e. If you have problems removing the spark plug, using the stock plug tool that comes in the kit that comes under the rear seat .I removed my gas tank slightly out of the way its very easy.Removing the two screws that hold it in place, and you can slide it slightly out of the way so you can reach the plugs from the top. I made sure i had all the tools and plugs near or on the seat while i supported tha tank out of the way using my upper legs and resting it sideways.Buy a gapping tool at your local car store auto zone advance auto for a dollar ,and gap your plugs mine didnt come pre gapped.The gap setting is .07 to .08 i believe or you can call your dealer they should have the answer if you got them from them.Dont use a torque wrench or anti seize they can just complicate this process.The plug tool an extension with a 9/16 socket should be long enough using a ratchet wrench.once gapped slide the plug in,rotate backwards until you hear a click, this means plug threads are alinged and wont cross thread.Keep rotatting counter clock wise until you feel comfortable that the plug threads are alinged this is critical.Once threads are alinged turn plug using wrench extension 9/16 socket setup on the stock plug tool.Dont use much force once it stops turning give it half a turn there the plug is set. I hope this is helpful thankx;)

Posted on Oct 29, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

Consult the owners manual if available for your model yer if possible, but NGK CR7HS sounds about right, I do not suggest getting motorcycle parts at an autoparts store, This is one time where one should always go to the dealer. Don't know where you are located, if its unusually warm or cold weather the dealer might suggest a slightly colder or hotter heat range on the spark plug. Always gap and torque your plugs to facotry specs!
My personal experience is the NGK plugs work best in Kawasaki motorcycles. Tried others and always go back.

Posted on Jul 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 92 Kawasaki 250 just got it but the thing is I Dnt know wht kind of oil to use for it


You must be more specific about exactly what model 250 you have. ie; KX, Ninja, KLR???? Also in which area does this oil go as in the KX, it would use a 2cycle oil in the gasoline premix and a transmission oil in the gearbox.

Jan 14, 2013 | Motorcycles

1 Answer

99 kawasaki ninja EX250 motor swap for a 98 NINJA EX250 MOTOR


I would try charging the battery. Take it off and put it on a slow trickle charge overnight. Batteries usually only last 3-4 years if it is an acid battery.

Nov 27, 2011 | kawasaki Kawasaki Ex250f11 Ninja 250r...

1 Answer

2002 ninja 250 idels good runs bad with no power band and sounds like its running on two cylinders but both exhaust pipes get hot,it just doesnt sound like a ninja should,i put new plugs with no change


The power band on a 2002 Ninja 250 does not kick in till you hit about 5000 RPM. The newer 2008 and up 250's kick in about 3000 RPM. There is a website devoted to the Ninja 250 that might give your more background into the motorcycle: ninjette.org You may want to replace your spark plug caps they may be robbing of the spark you need at take off. They simply unscrew off of the end of the wires. They should read 5000 OHM's no higher , no lower. If you purchase new NGK brand plug caps they will only cost about $5 each.

Jun 05, 2011 | 2008 kawasaki Ninja 250R

1 Answer

My 2005 ninja 250 is only starting when i use starter fluid.


your carbs need cleaning your fuel pickup tube for you cold start is blocked.

May 14, 2010 | kawasaki Ninja 250R Motorcycles

1 Answer

I dont have a manual. I need to know what type of


http://bikerpunks.com/media/other_files/15021361-Kawasaki-Ninja-250-Service-Manual2.pdf

Mar 21, 2010 | 2008 kawasaki Ninja 250R

1 Answer

Would the fairing parts of a 2006 kawasaki ninja 250 fit a 2005 kawasaki ninja 250?


Yes I do believe they do. Try going to Powersportseast.com Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul

Nov 02, 2009 | 2008 kawasaki Ninja 250R

1 Answer

Need to install starter on 2005 ninja 250


May I suggest a trip to your local library. Cycle repair books should be in 646 stacks of reference.

Oct 05, 2009 | 2005 kawasaki 250 TR

1 Answer

250 ninja dropped on right side at 0mph. signal broken and scratches around signal. how much to repair?


Go to Powersportseast.com and look up your bike on the Parts Fische. It will give prices and you can order thru them if you want. Signals are the cheap part by a long shot! I have been rebuilding a Salvage 08 250 ninja and have had to replace A LOT on it. The plastics alone are around 250-350. If it is really bad on the plastic try Ebay and wait till you find exactly what you need. The signal is around 40 bucks give or take

Oct 02, 2009 | 2008 kawasaki Ninja 250R

1 Answer

89 kawasaki ninja 250 crank no start


ok i have one and i just fixed mine you need to drain the fuel from bottom of carbs and drain the tank also. then replace the spark plugs once you do that add new fuel in tank and drain the carbs again unitil good fule start runing out then shut them off. aftre that make sure there are two line connected to the petcock from the carb. spray soem starting fluid in the air box and chock it boom it will start. if it has spark.

chris

Jul 12, 2009 | 2008 kawasaki Ninja 250R

1 Answer

2001 250 ninja


make sure you are checking the timing using the number 2 cylinder, no the number one.

Feb 24, 2009 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
2008 kawasaki Ninja 250R Logo

841 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...