Question about 2006 kawasaki KX 450 F

1 Answer

Kx f 250 won't idle

Will idle fine than when i rev it the idle stays up high than after 20 secs drops down

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Check and make sure there is no trash in the carb. to do so take off the float bowl which is on the bottom if the carb then see if gas comes out while the float is down, if there is no gas then take off the float (pull out the little pin) then the float needle, then with an air hose blow through the hole that the float needle was in.

Posted on Jul 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i start up my kawsaki kx 250 2stroke with the choke on it revs real high until i push it down is this normal


Yes.... try to turn the choke off as soon as possible after start, a cold motor reving hard is not a great idea!.

Cheers.

Nov 29, 2013 | 2007 HM CRE F250R

1 Answer

I need air mix settings for a 1996 zzr 250 kawasaki


it sounds like your low speed idle jets are still cloged as they are very small openings you may need to soak them in thinners then use a air compresser to blow them out ,and see if you can see through them ,i have found a steel guitar string the smallest can fit some of them hope it works cheers

Apr 07, 2013 | 1992 kawasaki ZZR 250

1 Answer

My 94 nissan patrol won't idle


if you mean it stalls at idle speed then it needs a service, the idle jets seem to be blocked and need a clean.
if you mean the engine stays and high rev and will not go down to idle this might mean the automatic choke is stuck on or the throttle cable is jammed and should be looked at.

I hope this was useful.

Oct 20, 2012 | Cars & Trucks

1 Answer

While driving the engine stays at 3000rpm for 2sec and drops


hi,just a thought,if you have had two sets of carbs on it and they have been tuned/balanced and still does it,then it is probably not the carbs causing the problem.check your throttle cable,check it is in good condition with no kinks or tight spots,also check it is not jammed between any other component causing a sticky spot,also,check the freeplay in the cable,you should have around a 1/4 " freeplay at the carbs,with the engine running turn the steering lock to lock,the engine revs shouldn't change..s aticky cable can cause the problem you describe.hope this helps...cheers

Apr 16, 2010 | 1990 Yamaha FZR 600

2 Answers

I have a 03 tiburon gt 2.7 and when you hit the gas the engine revs up to about 3100rpm for about 10 secs the drops down to about 1500 and surges up and down form 1500rpm to 2000rpm then it will idle...


its gonna be your clutch i had the same problem, when i floor it the rpms would go high then drop and take off i replaced it and it runs fine know

Feb 13, 2010 | 2003 Hyundai Tiburon

2 Answers

High rev on stat up and stays lik that


Have you had it scanned for codes?

May 17, 2009 | 1994 Ford Taurus

3 Answers

I have a 1981 Honda CT110 Trail 2 wheel motorcycle. I have been working on it and everything seems to be working normal except the idle. It will idle normal for a time and the suddenly rev real high. I...


The problem is an air leak leaning the fuel mix. The idle speed starts going up a ramp until it is wide open. The valves no longer seating well is a possible cause as is carb manifold gaskets, rings and a cylinder head not torqued down tight.

Apr 23, 2009 | 1982 Honda VT 250 F

1 Answer

Wr 200 power problems


Unhook exhaust pipe,check port for blockage. if it is clear try to rev up with pipe off.If exhust is clear you will need to check high side of carb. good luck

Mar 24, 2009 | 2003 Yamaha WR 250 F

2 Answers

Wont rev past 3/8 throttle!! I NEED HELP.


could be. I had a 91 kx 250 that was acting crazy and it turned out to be the stator and cdi box. you can check the stator easly with a omes meter but the cdi box is nearly impossible to check. you pretty much have to buy a new one and try it. also check to see if your power valve is working.

Jan 19, 2009 | 2004 Yamaha YZ 250 F

Not finding what you are looking for?
2006 kawasaki KX 450 F Logo

Related Topics:

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...