Question about 2007 Suzuki Burgman 650

1 Answer

650 burgman 2007 model misfiring and won't idle

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Suzuki Master
  • 39,945 Answers

Hi, David and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking check for spark leakage in the dark
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Dirty air filter.
10. Intake air leak.
11. Water, dirt, or rust in the fuel system, carburetor and/or filter.
12. Old dead or bad fuel.
13. Fuel tank vent system plugged or carburetor vent line closed off.
14. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
15. Carburetor controls misadjusted.
16. Damaged carburetor.
17. Incorrect valve timing.
18. Weak or broken valve springs.
19. Damaged intake or exhaust valve.
20. Check for engine trouble codes
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Scooter dies sporadically in idle Page 6 Suzuki Burgman Forum
Easy fix for unstable idle suzuki skywave burgman
Suzuki AN650 Service Manual
OEM parts for Suzuki
Suzuki burgman 650 owners manual

Posted on Dec 21, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ECM located on a 2007 Suzuki 650 Bergman scooter?


Hi, Mike for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
2007 Suzuki 650 Burgman ECM location Google Search
http://burgmanusa.com/forums/15-burgman-650/45951-ecm-failure.html
Suzuki AN650 Service Manual
OEM parts for Suzuki

Oct 24, 2016 | 2007 Suzuki Burgman 650

1 Answer

I have a customers 2007 Suzuki 650 Burgman on my lift why is it more difficult to roll backwards


Was it running when you tried to back it up? I do NOT have any experience with this bike or this CVT propulsion however, the old SIMPLEX AUTOMATIC used a less sophisticated design.

There is a reinforced belt that slips when stopped or backing up but it always drags to some extent just much less if the motor is NOT running.

Check out this forum: http://burgmanusa.com/forums/15-burgman-650/32233-hard-back-up-why-2.html

Dec 09, 2015 | 2007 Suzuki Burgman 650

1 Answer

Where can i see rectifier on my burgman 125uh 2003 model..which part of the scooter thanks in advance


650 Regulator Rectifier experience - Suzuki Burgman Forum - BurgmanUSA

burgmanusa.com/...burgman.../49945-650-regulator-rectifier-experience...
Apr 18, 2012 - This is my experience swapping out my rectifier with an aftermarket Mosfet unit. I have no long term review right now but here are some ... scooter stalls at low rpm's - Suzuki Burgman Forum
May 23, 2015
Starting / Electrical issue with 2008 Burgman 400 - Suzuki ...
Feb 14, 2013
2003 650 CVT motor issues! - Suzuki Burgman Forum
Dec 9, 2010
OIL LIGHT ON - Suzuki Burgman Forum - BurgmanUSA
Apr 17, 2004
More results from burgmanusa.com

How to wire a GY6 scooter regulator / rectifier and how it all ...

? 4:56
www.youtube.com/watch?v=u8dGhevthRI

Oct 28, 2009 - Uploaded by serpentza
How to wire a GY6 scooter regulator / rectifier and how it all works (Part 3 .... My scooter has no spark how to fix. gy6 chinese scooter 139qmb ...

Oct 28, 2015 | Motorcycles

1 Answer

Burgman 650 F1 light come on


water level or thermostate sensor gone.

Feb 26, 2015 | 2007 Suzuki Burgman 650 Exec

1 Answer

How do I adjust the idle on my Burgman 650?


Remove one screw and pull off the hump cover. The idle adjustment screw is up high, on the left side as you look forward. A standard philips screwdriver fits it. With the engine warmed up, turn it until your tach shows the speed that you want (1000-1200 as per the manual). Turning the screw to the right increases the idle speed, turning it to the left drops the idle speed.

Note: There are tabs that hold the engine cover in place after you remove the single screw. You will see indents at the bottom rear of the cover on both sides. Pull outward at each indent and you will hear the tab click free. Then lift up on the rear of the cover until it clears the seat and pull backward slightly to remove it.

I hope this helps.
--Robert

Oct 27, 2014 | 2007 Suzuki Burgman 650

2 Answers

Suzuki burgman 650 won,t change gear


I had the same problem until I found out that when you put the Burgman on it's center stand, it pushes a small round metal pin (spring loaded or something similar) that limits the Burgman to 1st gear only. Some kind of safety feature, I guess. You can see the little switch if you put the bike on it's side-stand, get down on the right hand of the bike and look where the centre stand meets with the body of the bike. My switch was stuck in permanent "on" so I just pulled the pin to it's full extention with a pair of pliars, then cut it with a junior hacksaw.

Mar 28, 2009 | 2003 Suzuki AN 650 Burgman

Not finding what you are looking for?
2007 Suzuki Burgman 650 Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...